An engineer needs to create a new user in the local user database on Cisco UCS Fabric Interconnect. The user needs permissions to change the following configuration inside UCS Manager version 3.1:
• vNIC and vHBA profiles
• Fan speed and power redundancy profile of UCS Manager
Which two roles must be assigned to a user to achieve this goal? (Choose two.)
Refer to me exhibit An engineer is troubleshooting a connectivity issue for a VM with MAC address 00:50:56:88:10:14 running on me cisco UCS-8 Series blade in VLAN 10. Cisco DCS Manager is connected to a Cisco nexus 9000 Series switch over port channel 10. Currently, the VM Is unreachable from any source that Is outside of me Cisco UCS domain. Which action musí be takenlo allow me VM to be readable?
Refer to the exhibit. An engineer configures a Cisco C-Series UCS server. The company policy states that all C-Series servers must be configured so that Cisco IMC is reachable only from the management port of the server. Which NIC configuration must the engineer apply to meet this objective?
Drag and drop the hyperflex characteristics from the left onto the appropriate. HyperFlex Node types on the right. Not all options are used.
Drag and drop the mechanisms to collect data from a network from the left onto their characteristics on the right.
Refer to the exhibit. Which command must be used to configure a VXLAN NVE tunnel interface such that MAC and IP address information are learned in the control plane?
Refer to the exhibit. A Cisco Nexus Dashboard Fabric Controller has been deployed to manage the configuration of the LAN through the management interface MgmtO of a Cisco Nexus switch Cisco Nexus Dashboard Data interface is Layer-2 adjacent to the Nexus switch MgmtO Interface. Which IP address must be allocated to the MgmtO interface?
Refer to the exhibit. An engineer must configure infrastructure monitoring in a Cisco UCS domain to monitor traffic on the Cisco fabric interconnect A and Cisco fabric interconnect B port links connected to Cisco MDS switches SW1 and SW2. The monitored traffic must be sent to Cisco Intersight at 20 Gbps for further analysis. Which command must be run on a UCS device after the create eth-mon-eession EthMonitor1/0 command is run?
Refer to the exhibit.
Two Cisco Nexus Series Switches use EIGRP between their Eth1/1 interfaces. The switches are configured to support EIGRP authentication. Which set of CLI
commands must be used to establish EIGRP neighborship?
In a data center based on Cisco Nexus 9000 Series Switches, all endpoints support explicit congestion notifications How does the Nexus switch respond when the ECN-enabled queue reaches the maximum WRED threshold?
