Summer Certification Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: force70

Pass the Cisco CCNP Data Center 350-601 Questions and answers with CertsForce

Viewing page 7 out of 13 pages
Viewing questions 61-70 out of questions
Questions # 61:

An engineer installed a new Nexus switch with the mgm0interface in vrf management. Connectivity to the rest of the network needs to be tested from the guest shell of the NX-OS. Which command tests connectivity from the shell of the NX-OS?

Options:

A.

[guestshell@guestshell -]$ ping 173.37.145.84 vrf management


B.

[guestshell@guestshell -]$ chvrf management ping 173.37.145.84


C.

[guestshell@guestshell -]$ iping vrf management Ip 173.37.145.84


D.

[guestshell@guestshell -]$ dohost " ping vrf management 173.37.145.84 "


Expert Solution
Questions # 62:

Question # 62

Refer to the exhibit. In a Cisco ACI fabric, the status of interface Eth1/1 changes frequently. Which set of actions configures the fabric to disable Eth1/1 when the port flaps more than 10 times within 1 minute?

Options:

A.

From fabric policies, set the time allowed for max flaps to 60.


B.

From fabric policies set link debounce interval to 60.


C.

From access policies, set the time allowed for max flaps to 60.


D.

From access policies, set link debounce interval to 1.


Expert Solution
Questions # 63:

A cisco mds 9000 series switch must automatically learn about devices and

switches connected to a fibre channel interface. However

a conflicting entry exists in the configuration database.

Which set of actions activates the configuration database?

Options:

A.

Enforce port security Disable auto-learning


B.

Activate port security Enable auto-learning


C.

Disable port security Lock down the fabric


D.

Enable auto-learning Activate port security


Expert Solution
Questions # 64:

Which FC mode is the device MDS-9148S-2 operating in?

Question # 64

Options:

A.

FPMA


B.

NPV


C.

FDISC


D.

NPIV


Expert Solution
Questions # 65:

Question # 65

Refer to the exhibit. An engineer must configure a QoS policy that controls only vHBA traffic. Which policy must be used to meet this requirement?

Options:

A.

Best Effort


B.

Fibre Channel


C.

Gold


D.

Platinum


Expert Solution
Questions # 66:

Question # 66

Question # 66

Refer to the exhibit. An FCoE-attached storage connects to a Cisco Nexus 9000 Series Switch on interface ethernet1/12. After the configuration was performed. VSAN 200 failed to activate on the vfc interface. Which configuration action must be performed to bring up VSAN 200?

Options:

A.

Configure interface vfc 10 as a node port.


B.

Trunk the FCoE VLAN on interface vfc 10.


C.

Change the native VLAN on the trunk port.


D.

Bind VSAN 200 on interface ethernet1/12.


Expert Solution
Questions # 67:

An engineer must apply AAA configuration on a Cisco MDS 9000 Series Switch The solution must meet these conditions :

    It must use a challenge-response authenticator protocol that uses MD5 hashing with an incrementally changing identifier

    The RADIUS configuration must be automatically shared with other MDS switches in the environment

The RADIUS server is already defined. Which command set completes the configuration?

A)user naed

Question # 67

B)

Question # 67

C)

Question # 67

D)

Question # 67

Options:

A.

Option A


B.

Option B


C.

Option C


D.

Option D


Expert Solution
Questions # 68:

Question # 68

Refer to the exhibit. A Cisco data center environment is implemented with vPC. The web server replies using the SVI MAC address as the Layer 2 header instead of the HSRP MAC address on VLAN 23. This behavior causes packet drops on the Cisco Nexus 9000 Series Switches due to the vPC loop prevention mechanism The requirement is for the vPC feature to allow N9K_1 and N9K_2 to forward traffic between the NAS server and the web server, even if the HSRP ' s MAC address is not used on Layer 2 headers for VLAN 23. Which feature must be used to accomplish this goal?

Options:

A.

Peer Gateway


B.

ARP Sync


C.

L3 Peer Router


D.

Object Tracking


Expert Solution
Questions # 69:

Refer to the exhibit. A source is sending a multicast traffic stream to the receiver. How is the multicast traffic expected to flow through the network when it reaches a vPC peer?

Options:

A.

The multicast traffic is not replicated to the ports that joined a multicast group (224.0.0.13) or the peer link. The multicast traffic stream flows from Agg-1 to Agg-2 over the M1-to-M2 peer link and forwards the traffic over Layer 4 to Access-2.


B.

The multicast traffic is replicated to the ports that joined a given multicast group and the peer link. The multicast traffic stream flows from Agg-1 to Agg-2 over the M1-to-M2 peer link and forwards the traffic over Layer 4 to Access-2.


C.

The multicast traffic is not replicated to the ports that joined a multicast group (224.0.0.13) or the peer link. The multicast traffic stream flows over the vPC link to ensure that orphan ports get the multicast stream in failure scenarios.


D.

The multicast traffic is replicated to the ports that joined a given multicast group and the peer link. The multicast traffic stream flows over the peer link to ensure that orphan ports receive the multicast stream in failure scenarios.


Expert Solution
Questions # 70:

Question # 70

Refer for the exhibit. A network administrator is creating a JSON payload to provision multiple EPGs within an application profite. All EPGs must be created in a single HTTP POST. Which data structure must be used after the " children " parameter to create.

Options:

A.

whitespace


B.

object


C.

string


D.

array


Expert Solution
Viewing page 7 out of 13 pages
Viewing questions 61-70 out of questions