Cisco 350-601 Exam Questions Free Practice Test

Viewing page 8 out of 13 pages

Viewing questions 71-80 out of questions

Questions # 71:

An engineer must integrate Cisco ACI with a VMware vSphere environment The requirement is to use a VMware Distributed Virtual Switch and to assign the encapsulation VLAN of the EPG from the VLAN pool Which configuration set accomplishes this goa?

Options:

Create a VMM domain association under the EPGs Create a VLAN pod with static alocated VLANs.

Create a physical domain association under the EPGs Create a VLAN pool with static alocated VLANs.

Create a physical domain association under the EPGs. Create a VLAN pool with dynamic alocated VLANs

Create a VMM domain association under the EPGs Create a VLAN pool with dynamic alocated VLANs.

Expert Solution

Questions # 72:

Refer to the exhibit.

Question # 72

An engineer must activate the port-security database on a Cisco MDS 9000 Series Switch for VSAN 100, but receives the error shown. Which command completes the

configuration?

Options:

port-security vsan 100 database active

port-security activate vsan 100 force

port-security enabled mode vsan 100

port-security config-enable vsan 100

Expert Solution

Questions # 73:

What is the DHCP snooping bindings file shown here used for by the Cisco Nexus 9000 Series Switch?

Question # 73

Options:

to retain the DHCP bindings configuration across reboots

to authenticate the users permitted to make the changes to the DHCP snooping feature

to retain the DHCP server configuration across rebootsD, to permit the users from the IP addresses listed to make changes to the DCHP configuration

Expert Solution

Questions # 74:

Refer to the exhibit An engineer must restrict users assigned to the sangroup role on the Cisco MDS 9000 Series Switch from issuing commands

on VSANs 15 to 20 Which command must the engineer run to achieve

this objective?

Question # 74

Options:

vsan policy deny vsan 15-20

no permit vsan 15-20

permit vsan 15-20

no vsan policy deny

Expert Solution

Questions # 75:

Which Cisco UCS component does an infra bundle “A” software upgrade?

Options:

BIOS

I/O module

adapter

board controller

Expert Solution

Questions # 76:

Question # 76

Refer to the exhibit. An engineer must capture Fibre Channel traffic from the server and the supervisor to the Cisco MDS 9000 Series Switch fabric. The traffic must be forwarded to the analyzer Drag and drop the code snippets from the right onto the blanks in the code on the left to complete the configuration. Not all code snippets are used.

Question # 76

Expert Solution

Questions # 77:

Refer to the exhibit.

Question # 77

A Cisco VXLAN data center is deployed using Cisco Nexus 9000 Series Switches. The deployment must meet the following requirements:

VTEP1 must learn the MAC addresses of User1 and User2 on interfaces Ethernet1/1 and Ethernet1/2.

VTEP2 must never age out the MAC address of the web server.

MAC addresses learned on VTEP1 interfaces must persist after the device or interfaces restart.

Which configuration accomplishes these goals?

Options:

interface ethernet1/2

switchport port-security mac-address sticky

interface ethernet1/3

switchport port-security aging type absolute

interface ethernet1/1

switchport port-security

interface ethernet1/2

switchport port-security mac-address static

interface ethernet1/3

switchport port-security aging type inactivity

interface ethernet1/1

switchport port-security mac-address A

interface ethernet1/2

switchport port-security

interface ethernet1/3

no switchport port-security

interface ethernet1/1

switchport port-security

interface ethernet1/2

switchport port-security mac-address B

interface ethernet1/3

switchport port-security aging time 0

interface ethernet1/1

switchport port-security mac-address A

Expert Solution

Questions # 78:

An engineer must configure a Cisco MDS 9000 Series Switch for traffic analysis from the storage array. The storage array is connected to the interface fc2/1 in VSAN 10 and the traffic analyzer to fc4/2. The capture file must include ingress and egress traffic between the switch and the storage array. Also, only traffic in VSAN 10 must be captured. Which configuration set meets these requirements?

Options:

interface fc4/2switchport mode SD no shutdown!span session 1 source interface fc2/1 destination interface fc4/2 source filter vsan 10

Interface fc4/2switchport mode trunk switchport trunk allow vsan 10 no shutdown!span session 1 source interface fc2/1 tx destination Interface fc4 ' 2 rx no suspend

Interface fc4/2switchport mode auto no shutdown!span session 1 source interface fc2/1 rx destination interface fc4/2 source filter vsan 10 no suspend

interface fc4/2 switchport mode STno shutdown!span session 1 source interface fc2/1 destination interface fc4/2 source filter vsan 10

Expert Solution

Questions # 79:

Question # 79

Refer to the exhibit. A network engineer must monitor the traffic from the server on VLAN 80.

All source traffic from the server must be captured on the monitoring device. Which configuration set meets these requirements?

Question # 79

Options:

Option A

Option B

Option C

Option D

Expert Solution

Questions # 80:

What occurs when the following command is run on a Cisco Nexus 9000 Series Switch?

Nexus01# install all epld n9000-epld.9.2.4.img

Options:

It displays the compatibility between the EPLD upgrade and the switch.

It triggers a disruptive EPLD upgrade on the switch.

It triggers a simulated EPLD upgrade on the switch.

It displays the operational impact of the EPLD upgrade.

Expert Solution

Viewing page 8 out of 13 pages

Viewing questions 71-80 out of questions

Summer Certification Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: force70

Pass the Cisco CCNP Data Center 350-601 Questions and answers with CertsForce