Cisco 350-501 Exam Questions Free Practice Test

Viewing page 7 out of 11 pages

Viewing questions 91-105 out of questions

Questions # 91:

Refer to the exhibit.

Question # 91

An engineer configured multicast routing on client's network. What is the effect of this multicast implementation?

Options:

R2 floods information about R1 throughout the multicast domain.

R2 is unable to share information because the ip pirn autorp listener command is missing.

R1 floods information about R2 throughout the multicast domain.

R2 is elected as the RP for this domain.

Expert Solution

Questions # 92:

An engineer is setting up overlapping VPNs to allow VRF ABC and XYZ to communicate with VRF CENTRAL but wants to make sure that VRF ABC and XYZ cannot communicate. Which configuration accomplishes these objectives?

Question # 92

Options:

Option A

Option B

Option C

Option D

Expert Solution

Questions # 93:

What is one of the main functions of 6RD?

Options:

It provides stateful session translation with the 2002::/16 prefix.

It translates RFC 1918 IP addresses into public IP addresses.

It provides native reachability between IPv4-only hosts and 6RD-enabled IPv6 hosts.

It allows customers IPv6 traffic to be tunneled over IPv4 network infrastructure.

Expert Solution

Questions # 94:

Question # 94

Refer to the exhibit. A network engineer configures CPE-1 for QoS with these requirements:

IPv4 and IPv6 traffic originated by the CPE-1 WAN IP address must be marked with DSCP CS3.

IPv4 LAN traffic must be marked with DSCP CS1.

IPv6 LAN traffic must be marked with DSCP default.

Which configuration must the engineer implement on CPE-1?

Options:

class-map match-any SELF_TRAFFIC

match access-group name SELF_V4

match access-group name SELF_V6

class-map match-all V4_ TRAFFIC

match protocol ip

class-map match-all V6_TRAFFIC

match protocol ipv6

class-map match-all QG_4

match qos-group 4

class-map match-all QG_6

match qos-group 6

policy-map LAN-INPUT

class V4_TRAFFIC

set qos-group 4

class V

class-map match-all SELF_TRAFFIC

match access-group name SELF_V4

match access-group name SELF_V6

class-map match-all V4_ TRAFFIC

match protocol ip

class-map match-all V6_TRAFFIC

match protocol ipv6

class-map match-all QG_4

match qos-group 4

class-map match-all QG_6

match qos-group 6

policy-map LAN-INPUT

class V4_TRAFFIC

set qos-group 4

class V

class-map match-all SELF_TRAFFIC

match access-group name SELF_V4

match access-group name SELF_V6

class-map match-all V4_ TRAFFIC

match protocol ip

class-map match-all V6_TRAFFIC

match protocol ipv6

class-map match-all QG_4

match qos-group 4

class-map match-all QG_6

match qos-group 6

policy-map LAN-INPUT

class V4_TRAFFIC

set qos-group 4

class V

class-map match-any SELF_TRAFFIC

match access-group name SELF_V4

match access-group name SELF_V6

class-map match-all V4_ TRAFFIC

match protocol ip

class-map match-all V6_TRAFFIC

match protocol ipv6

class-map match-all QG_4

match qos-group 4

class-map match-all QG_6

match qos-group 6

policy-map LAN-INPUT

class V4_TRAFFIC

set qos-group 4

class V

Expert Solution

Questions # 95:

Refer to the exhibit.

Question # 95

The CE router is peering with both PE routers and advertising a public prefix to the internet. Routing to and from this prefix will be asymmetric under certain network conditions, but packets must not be discarded. Which configuration must an engineer apply to the two PE routers so that they validate reverse packet forwarding for packets entering their Gi2 interfaces and drop traffic from the RFC1918 space?

Options:

ip verify unicast source reachable-via rx allow-default

interface GigabitEthernet 2

ip verify unicast source reachable-via rx

ip verify unicast source reachable-via any allow-default

interface GigabitEthernet 2

ip verify unicast source reachable-via any

Expert Solution

Questions # 96:

An engineer must implement QoS to prioritize traffic that requires better service throughout the network. The engineer started by configuring a class map to identify the high-priority traffic. Which additional tasks must the engineer perform to implement the new QoS policy?

Options:

Attach the class map to a policy map that sets the minimum bandwidth allocated to the classified traffic and designates the action to be taken on the traffic.

Attach the class map to a policy map that designates the action to be taken on the classified traffic and then attach the policy map to an interface using a service policy.

Attach the class map to a policy map within a VRF to segregate the high-priority traffic and then attach the policy map to an interface in another VRF.

Create a route map to manipulate the routes that are entered into the routing table and then attach the route map to an interface using a service policy.

Expert Solution

Questions # 97:

Refer to the exhibit.

Question # 97

The network engineer is performing end-to-end MPLS path testing with these conditions:

• Users must perform MPLS OAM for all available same-cost paths from R1 to R4.

• Traceroute operations must return all of the next-hop IP details.

Which configuration meets these requirements?

Options:

traceroute mpls ipv4 10.10.10.4 255.255.255.255 verbose

traceroute mpls multipath ipv4 10.10.10.4 255.255.255.255

traceroute mpls multipath ipv4 10.10.10.4 255.255.255.255 verbose

traceroute mpls ipv4 10.10.10.4 255.255.255.255 source 10.10.10.1

Expert Solution

Questions # 98:

Which statement describes the advantage of a Multi-Layer control plane?

Options:

It automatically provisions monitors, and manages traffic across Layer 0 to Layer 3

It minimizes human error configuring converged networks

It supports dynamic wavelength restoration in Layer 0

It provides multivendor configuration capabilities for Layer 3 to Layer 1

Expert Solution

Questions # 99:

A network architect must implement CSC VPN services for a new backbone carrier. Which two benefits does the architecture provide? (Choose two.)

Options:

It maintains.a single backbone, which simplifies the VPN implementation to customers.

It eliminates the need to maintain a centralized network-maintenance and operations strategy.

It leverages IPsec to establish connections within the backbone. which eliminates the need for BGP to distribute routes.

It supports a scalable growth strategy that services multiple customers efficiently

It relies on IP communications, which simplifies the network design.

Expert Solution

Questions # 100:

Refer to the exhibit:

Question # 100

Which statement about the status of the neighbor relationship between R1 and R2 is true?

Options:

The neighbor relationship is down because the two routers are configured with different area types

The neighbor relationship is down because the two routers are in the same subnet.

The neighbor relationship is up because R2 is level 1 and level 2 router.

The neighbor relationship is down because R2 is operating as a Level 1 router and the two routers are in different area

Expert Solution

Questions # 101:

The NOC team must update the BGP forwarding configuration on the network with these requirements:

BGP peers must establish a neighborship with NSF capability and restart the session for the capability to be exchanged after 120 seconds.

BGP peers must delete routes after 360 seconds of inactivity.

Which action meets these requirements?

Options:

Set the BGP restart-time to 120 seconds and the BGP ha-mode sso to 360 seconds.

Set the stalepath-time to 120 seconds and the BGP restart-time to 360 seconds.

Set the BGP ha-mode sso to 120 seconds and the BGP restart-time to 360 seconds.

Set the BGP restart-time to 120 seconds and the stalepath-time to 360 seconds.

Expert Solution

Questions # 102:

Refer to the exhibit.

Question # 102

A network administrator implemented MPLS LDP changes on PE-A LSR device. The engineer must ensure there are no LDP peer are fully operational. Which LDP feature must the engineer apply to the existing configuration to eliminate the problem?

Options:

Configure MPLS LDP IGP synchronization on the network.

Configure MPLS LDP NSR for all LDP sessions.

Enable LDP session protection under the routing protocol.

Disable IP CEF on routers running LDP and enable LDP.

Expert Solution

Questions # 103:

An engineer is implementing MPLS to monitor within the MPLS domain. Which must the engineer perform to prevent packets from being forwarded beyond the service provider domain when the LSP is down?

Question # 103

Options:

Option A

Option B

Option C

Option D

Expert Solution

Questions # 104:

An organization with big data requirements is implementing NETCONF as part of its migration to a new cloud-based environment. The organization has multiple offices across widespread geography. A network engineer is configuring NETCONF on one of the border routers. Which configuration must the engineer apply to save the running configuration?

Options:

snmp-server community public RW

snmp-server trap link left

snmp-server enable traps snmp authentication linkdown linkup

snmp-server enable traps syslog

snmp-server manager

logging history debugging

logging snmp-trap emergencies

logging snmp-trap alerts

logging snmp-trap critical

logging snmp-trap errors

logging snmp-trap warnings

logging snmp-trap notifications

logging snmp-trap information

logging snmp-trap debugging

Expert Solution

Questions # 105:

Refer to the exhibit.

Question # 105

A network operator must configure CSR1 interlaces GigabitEihernet2 and GigabitEthemet to rewrite VLAN tags 12 and 21 for traffic between R1 and R2 respectively. Which configurator accomplishes this task?

Question # 105