Winter Sale Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: pass65

Pass the Cisco CCNP Collaboration 350-801 Questions and answers with CertsForce

Viewing page 6 out of 13 pages
Viewing questions 51-60 out of questions
Questions # 51:

An engineer encounters third-party devices that do not support Cisco Discovery Protocol. What must be configured on the network to allow device discovery?

Options:

A.

LLDP


B.

TFTP


C.

LACP


D.

SNMP


Expert Solution
Questions # 52:

What is the maximum one-way latency and jitter for voice before quality issues arise?

Options:

A.

≤ 100 ms Latency and S 10 ms jitter


B.

≤ 150 ms Latency and s 30 ms jitter


C.

≤ 90 ms Latency and <30 ms jitter


D.

≤ 300 ms Latency and < 60 ms jitter


Expert Solution
Questions # 53:

An engineer configures local route group names to simplify a dial plan. Where does the engineer set the route group according to the local route group names that are configured?

Options:

A.

CSS


B.

device pool


C.

route list


D.

route pattern


Expert Solution
Questions # 54:

What is the traffic classification for voice and video conferencing?

Options:

A.

Voice is classified as CoS 4, and video conferencing is CoS 5.


B.

Voice and video conferencing are both classified is CoS 3.


C.

Voice is classified as CoS 5, and video conferencing is CoS 4.


D.

Video conferencing is classified as CoS 1, and voice is CoS 2.


Expert Solution
Questions # 55:

Which DSCP PHB classification must be used to configure QoS for voice on a high-speed network?

Options:

A.

EF


B.

CS4


C.

AF43


D.

43


Expert Solution
Questions # 56:

An engineer is configuring a phone system CISCO UCM and wants to activate TFTP service. The engineer selects the serviceability page for configuration. Which nodes configurable for TFTP?

Options:

A.

any two nodes


B.

any node


C.

only nodes that have Cisco UCM service enabled


D.

any subscriber nodes


Expert Solution
Questions # 57:

Question # 57

Refer to the exhibit. An administrator configured a codec preference list with 0,122 and ILBC codecs. Which change must the administrator make in the dial-peer section of the configuration to use this list?

Options:

A.

add voice-codecs 20


B.

add session codec 20


C.

add codec preference 20


D.

add voice-class codec 20


Expert Solution
Questions # 58:

A network engineer must convert an inbound number 14085551111 when it reaches Cisco UCM and then converts it to an internal extension 3022, so it can ring to a specific desk. Which action meets this requirement?

Options:

A.

Create a route group and route list and assign it to the translation pattern.


B.

Create translation pattern 14085551111, called party transform mask 3022.


C.

Change the partition and calling search space on the DID for the specific desk.


D.

Create a route pattern 9.1XXXXXXXXXX and assign it to the trunk.


Expert Solution
Questions # 59:

An administrator is asked to implement toll fraud prevention in Cisco UCM, specifically to restrict off-net to off-net call transfers. How is this implemented?

Options:

A.

Enforce ad-hoc conference restrictions.


B.

Set the appropriate service parameter.


C.

Implement time-of-day routing.


D.

Use the correct route filters.


Expert Solution
Questions # 60:

A company deploys centralized cisco ucm architecture for a hub location and two remote sites.

*The company has only one ITSP connection at the hub connection, and ITSP supports only G.711 calls

*Remote site A has a 1-Gbps fiber connection to the hub connection and calls to and from remote side A use G.711 codec

*Remote site B has a 1 T1 connection to the hub location and calls to and from remote site B use G.729 codec

Based on the provided guidance, a Cisco voice engineer must design media resource management for the customer What is the method that needs to be followed?

Options:

A.

configure the hardware transcoder on the site B router


B.

configure the hardware transcoder on the site A router


C.

configure the hardware transcoder on the hub location router


D.

configure the software transcoder on Cisco UCM to support voice calls to and from both remote sites


Expert Solution
Viewing page 6 out of 13 pages
Viewing questions 51-60 out of questions