Pass the Huawei HCIP-WLAN H12-322 Questions and answers with CertsForce

1+1

2+2

1+2

3+1

AP calculator

AP positioning

WLAN signal simulation

Export the bill of materials

2

4

6

8

The hangover network can perform WLAN deployment without modifying the physical topology of the live network, which facilitates network transformation.

When the network is bypassed, the AC can no longer bear the gateway of the service WLAN.

Using the “side-by-side networking + direct forwarding” network architecture can reduce the burden on the AC and improve network forwarding performance.

When the network is connected to the network, the AC can be connected to the aggregation layer or the core layer switch, but it must be the same network segment as the AP.

Single-flow single-frequency omnidirectional antenna

Single-current dual-frequency omnidirectional antenna

Dual-current single-frequency directional antenna

Dual-stream dual-frequency directional antenna

VRRP backup

N+1 hot backup

Stacking hot standby

N+1 cold backup

PoE switches are low cost

Remotely manage PoE ports

No additional power cord required

Can be managed centrally

UPS equipment is no longer needed

Indoor-mounted APs are suitable for scenes with high wireless user density

Compared with indoor distributed AP, the indoor radio type AP has a large transmitting power.

Compared with indoor distributed AP, the indoor radio type AP has low transmission power

Indoor-mounted APs are suitable for scenarios with low wireless user density

Omnidirectional antennas are easier to plan than directional antennas

Try to use omnidirectional antennas for planning

Suitable areas for directional antennas such as pedestrian streets

omnidirectional antenna is preferred when the coverage distance is long

Confirm the overall rules of the route, you need to confirm with the owner whether you can punch through the wall, whether you can take the open line, whether there is conditional hidden line, the network cable is

Do you want to use a wire slot or add a conduit?

In the survey process, the length of the trace should be calculated according to the actual environment, and the length of the trace is not required.

If the AP needs AC power supply, it needs to confirm the location of the power supply. If there are special requirements for the route in some locations, additional marking is required.

In the outdoor scene survey, each outdoor AP installation location needs to consider the routing problem.