Pass the CWNP CWNA CWNA-106 Questions and answers with CertsForce

Viewing page 2 out of 4 pages
Viewing questions 11-20 out of questions
Questions # 11:

What statement about 802.3-2012, Clause 33 Power over Ethernet is true?

Options:

A.

Up to 30 watts of power may be provided through an Ethernet cable.


B.

By using CAT3 cabling, you can increase the maximum draw available to the PD.


C.

When using CAT5 cabling, you decrease the maximum draw available to the PD.


D.

Only endpoint PSEs are supported.


E.

Only midspan PSEs are supported.


Expert Solution
Questions # 12:

What statement about the IEEE 802.11e QoS facility is true?

Options:

A.

802.11 QoS is achieved by giving high priority queues a statistical advantage at winning contention.


B.

Four 802.1p user priorities are mapped to eight 802.11 transmit queues.


C.

When the Voice queue has frames awaiting transmission, no data will be transmitted from the Best Effort queue.


D.

To improve efficiency, Block Acknowledgments are required for Voice and Video WMM queues.


E.

802.11 control frames are assigned to the 802.11 EF priority queue.


Expert Solution
Questions # 13:

As a station moves away from the access point to which it is associated, it changes its data rate from 600 Mbps to 540 Mbps and then to 450 Mbps.

What IEEE 802.11 term is used to describe this functionality?

Options:

A.

Dynamic Rate Switching


B.

Multirate Control


C.

Modulation and Coding Selection


D.

Rate Set Selectivity


E.

Adaptive Rate Management


Expert Solution
Questions # 14:

Your consulting firm has recently been hired to complete a site survey for a company. Your engineers use predictive modeling software for surveying, but the company insists on a pre-deployment site visit.

What tasks should be performed as part of the pre-deployment visit to prepare for a predictive survey? (Choose 2)

Options:

A.

With a spectrum analyzer, identify the type, amplitude, and location of RF interference sources, if any are present.


B.

Evaluate the building materials at ABC’s facility and confirm that the floor plan documents are consistent with the actual building.


C.

Test several antenna types connected to the intended APs for use in the eventual deployment.


D.

Collect information about the company’s security requirements and the current configuration of their RADIUS and user database servers.


E.

Install at least one AP on each side of the exterior walls to test for co-channel interference through these walls.


Expert Solution
Questions # 15:

What distinguishes an independent basic service set (IBSS) from an infrastructure basic service set (BSS)?

Options:

A.

An IBSS does not have a distribution system (DS), but a BSS does.


B.

An IBSS does not require beacon frames, but a BSS does.


C.

An IBSS does not support 802.11 authentication or association, but a BSS does.


D.

An IBSS does not support any 802.11ac enhancements, but a BSS does.


Expert Solution
Questions # 16:

ABC Company performs government contract work that requires disabling WLANs and has recently purchased an 802.11 Wireless Intrusion Prevention System (WIPS) to enforce their “NO WIRELESS” network security policy.

What attack type cannot be recognized by the WIPS?

Options:

A.

Deauthentication


B.

Rogue APs installation


C.

Layer 3 DoS


D.

Packet capturing


E.

RF jamming


Expert Solution
Questions # 17:

In a long-distance RF link, what statement about Fade Margin is true?

Options:

A.

Fade Margin is an additional pad of signal strength designed into the RF system to compensate for unpredictable signal fading.


B.

The Fade Margin of a long-distance radio link should be equivalent to the receiver’s antenna gain.


C.

A Fade Margin is unnecessary on a long-distance RF link if more than 80% of the first Fresnel zone is clear of obstructions.


D.

The Fade Margin is a measurement of signal loss through free space, and is a function of frequency and distance.


Expert Solution
Questions # 18:

ABC Company has just purchased a 6 dBi patch antenna. After performing some tests with the 6 dBi antenna, they have concluded that more antenna gain is needed to cover their outdoor courtyard. When choosing an antenna with higher gain, what other antenna characteristic will also always change?

Options:

A.

Fresnel Zone size


B.

Maximum input power


C.

Beamwidth


D.

Impedance


E.

VSWR Ratio


Expert Solution
Questions # 19:

An 802.11 WLAN transmitter that emits a 50 mW signal is connected to a cable with 3 dB of loss. The cable is connected to an antenna with 16 dBi of gain.

What is the EIRP power output?

Options:

A.

10 mW


B.

25 mW


C.

50 mW


D.

250 mW


E.

1000 mW


Expert Solution
Questions # 20:

When using an RF splitter to connect one transceiver to sector antennas loss is incurred. What is this loss called?

Options:

A.

Conversion loss


B.

Through loss


C.

Active loss


D.

Intentional loss


Expert Solution
Viewing page 2 out of 4 pages
Viewing questions 11-20 out of questions