New Year Sale Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: simple70

Pass the Cisco CCDE 352-011 Questions and answers with CertsForce

Viewing page 5 out of 8 pages
Viewing questions 41-50 out of questions
Questions # 41:

Question # 41


Expert Solution
Questions # 42:

A very large enterprise customer is migrating from EIGRP to IS-IS .What is your main concern in regards to change in the path packets take after the migration is complete?

Options:

A.

The areas sizes.


B.

The number of prefixes


C.

The redistribution points.


D.

The bandwidth and metrics of the links.


Expert Solution
Questions # 43:

What are two possible drawbacks of ending Loop-Free Alternate to support fast convergence for most destination IGP prefixes? (Choose two)

Options:

A.

The IGP topology might need to be adjust


B.

Loop-free alternate’s convergence in less than 100 milliseconds is not possible


C.

Loop-free alternate’s are supported only for prefixes that are considered external tot the IGP


D.

Loop-free alternates are not supported in global VPN VRF OSPF instances


E.

Additional path computations are needed


Expert Solution
Questions # 44:

Which option describes the fundamental design differences between an IP-based network design and a SAN-based?

Options:

A.

An IP-based design has redundant connectivity in the fabric and high amounts of east-west traffic, whereas a SAN-based design uses redundancy from a dual-attached host, which uses separate fabrics and has very little east-west traffic


B.

An IP-based design has redundancy from the host and high amounts of east-west traffic, whereas a SAN-based design uses redundancy in the fabric and very little east-west traffic


C.

An IP-based design has redundant connectivity in the fabric and high amounts of east-west traffic, whereas a SAN-based design uses zoning based redundancy which uses separate fabrics and has very little east-west traffic


D.

An IP-based design has redundant connectivity in the fabric and very little east-west traffic, whereas a SAN-based design uses redundancy in the host, which uses separate fabrics and has high amounts of east-west traffic


Expert Solution
Questions # 45:

You are reviewing a new data center design for a customer. They chose to leverage a tunnel-based overlay technology for quick deployment and multitenant security. Which design concern can affect the availability across the data center?

Options:

A.

Nonoverlapping IP address space between the overlay networks


B.

MTU size on the underlay links


C.

Review of comman paths on the underlay links


D.

Paper placement of STP root bridge in overlay networks


Expert Solution
Questions # 46:

As a network designer for a major multiservice network, your first assignment is to improve the IS-IS convergence to meet application requirements. Drag and drop the convergence tools or techniques to be used on your proposal from the left into the corresponding convergence phase on the right.

Question # 46


Expert Solution
Questions # 47:

What is design considerations of policy-based routing?

Options:

A.

It decreases failure detection time


B.

It can create microloops during network reconvergence


C.

It routes traffic destined to a set of users through different exit points


D.

It uses RSVP to differentiate traffic flows, so queuing mechanisms can prioritize them


Expert Solution
Questions # 48:

The enterprise customer ABC Corp will deploy a centralized unified communications application to provide voice, and instant messaging to their branch offices. Some of the branch offices are located in remote locations and are connected via a 1.5 Mb/s Layer 3 VPN connection. Which two ways are the most cost-effective to ensure that this new application is implemented properly? (Choose two)

Options:

A.

Use a low bitrate codec such as G 711


B.

Set voice activity detection to avoid sending packets when the conversations is silent


C.

Enable VRF-Lite on the CE router to create a separate voice VRF


D.

Set LFI on the WAN connections to interleave the small voice packets with the large data packets


E.

Set WAN optimization on the CE router to compress the voice packets for improved bandwidth utilization and performance


F.

Use a low bitrate codec such as G 729


Expert Solution
Questions # 49:

Which two statements regarding to QoS marking are true? (Choose two)

Options:

A.

Shaping is one of the ways that packets can be remarked


B.

Class-based marking occurs after packet classification


C.

802.1Q/p CoS bits and IP Precedence are both layer 3 marking fields


D.

QoS marking establishes a trust boundary that scheduling tools depend on


E.

MPLS EXP and DSCP are both layer 2 marking fields


Expert Solution
Questions # 50:

As part of network design, two geographically separated data centers must be interconnected using Ethernet-over-MPLS pseudowire. The link between the sites is stable, the topology has no apparent loops, and the root bridges for the respective VLANs are stable and unchanging. Which aspect must be the part of the design to mitigate the risk of connectivity issues between the data centers?

Options:

A.

Enable 802.1d on one data center, and 802.1w on the other.


B.

Ensure that the spanning tree diameter for one or more VLANs is not too large.


C.

Enable UDLD on the link between the data centers.


D.

Enable root guard on the link between the data centers.


Expert Solution
Viewing page 5 out of 8 pages
Viewing questions 41-50 out of questions