A company has 10 access point licenses available on their backup Cisco WLC and their primary Cisco WLC is at full capacity, 5 access points are set to high failover priority and 7 access points are set to critical failover priority. During a failure, not all critical access points failed over to the backup Cisco WLC. Which configuration
is the cause of this issue?
An engineer as performing a Layer 1 passive wireless site survey utilizing a channel analyzer software in the 2.4 GHz spectrum. Which chart indicates the ratio of interference present during the duration of the capture?
A)
B)
C)
A customer Wi-Fi deployment is experiencing the sticky client problem and must enable the optimized roaming feature. The wireless clients have valid security credentials for an SSID and can see an AP that offers that SSID to join. What must be configured to enhance roaming?
An engineer is designing a network deployment for a college with six buildings Each building must have a WLC located in the IDF to support the APs. The wireless clients should be able to roam between the APs and the controllers. Which type of wireless architecture should be used?
An engineer needs a wireless design to provide redundancy for APs at remote sites that are connected to Cisco 3504 Wireless LAN
Controllers. The central Cisco 5520 Wireless LAN Controller supports 2000 APs and has 1975 access points associated to it. The engineer decides that not all APs at the remote sites must remain functional in the event of a failure. How does the engineer ensure that the most important access points at the remote sites remain online while not impacting the main site?
An engineer has performed a predictive site survey for high-speed data and voice in an indoor office. What is the recommended data rate with -67 dBm signal level for optimal VoWLAN design?
An engineer working for an enterprise deployed multiple Cisco WLCs. A controller that sits in the R&D division is connected through a firewall and is part of the same mobility group. The engineer must ensure that the mobility tunneling is available through the firewall and test it as R&D engineers roam the production ..within their department. How is this requirement met?
An engineer must perform a pre-deployment site survey for a new building in a high-security area. The design must provide a primary signal RSSI of -65 dBm for the clients. Which two requirements complete This design? (Choose two)
An enterprise network administrator is asked to set up an experimental WLAN for a collaboration project with a local service provider. The WLAN must be anchored to a WLC in the service provider data center using legacy mobility mode. After the configurations are completed on the WLCs and the firewalls in the path, the data path mobility tunnel is failing to come up. What should be performed by the administrator to debug the issue?
Refer to the exhibit.
A customer is deploying a Greenfield 802.11n network with data, voice, and location awareness using APs with the WSSI modules. Which two settings in the Cisco Prime Infrastructure Planning Tool, when selected, provide a more accurate prediction of the number of APs the customer must purchase for the new facility? (Choose two.)
