Pass the Cisco CCNP Enterprise 300-425 Questions and answers with CertsForce

To support a high density of mobile devices and bond channels in groups of two, the channel width for 802.11a should be set to 40 MHz. Setting the data rates to 24 MB and Mandatory ensures that only APs can send 802.11 management frames at this rate, which helps in managing the airtime fairness. References: CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide.

 Before replacing old APs with IEEE 802.11ac-capable APs, it is crucial to check the software version of the wireless LAN controller. The controller’s firmware must support the newer standards and capabilities of 802.11ac APs. An outdated software version may not support the advanced features and performance enhancements offered by 802.11ac technology, leading to compatibility issues and suboptimal network performance.

References: CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide Premium Edition and Practice.

 The Cisco 5520 WLC v8.3 requires a base license to use OfficeExtend AP functionality, which allows remote workers to have the same wireless connectivity as they would in an office environment.

AP Fallback is a feature that allows APs to rejoin their primary controller after they have connected to a secondary controller due to a failure. By enabling AP Fallback on the primary controller, the APs will automatically rejoin it when it becomes available again after a power interruption. This ensures that APs return to their designated primary controller for normal operations.

For a wireless voice deployment, Cisco recommends that the edge of the cell should have a signal strength of -67 dBm to ensure reliable voice quality and seamless roaming capabilities.

The Voice Readiness tool within Cisco Prime Infrastructure is designed to assess the wireless network’s ability to support voice services, including VoIP. It evaluates various factors such as signal strength, noise levels, and coverage to ensure that the wireless network can handle the quality of service requirements needed for voice communications.

An active ping survey is used to validate network performance by sending and receiving data packets to measure the end-to-end network performance, including latency, packet loss, and throughput. Ekahau site survey tools can perform active ping surveys to test the connectivity and performance of the wireless network, ensuring that it operates as expected and meets the required service levels.

References := Configuring Active Surveys – Ekahau Customer Support

Setting the Anchor priority for the primary controller to 1 ensures that clients connect to the primary controller first. The Anchor priority is a value assigned to each controller within a mobility group to determine the order in which clients should connect to the controllers. A lower priority value has higher precedence. Therefore, by setting the primary controller’s Anchor priority to 1, it becomes the preferred controller for client connections. If the primary controller fails, clients are then pushed to the secondary controller, which should have a higher Anchor priority value.

 To predict the number of APs needed to support approximately 300 wireless devices on a new floor with an 802.11ac network, the Demand Settings in the Cisco Prime Infrastructure Planning Tool must be adjusted. This setting allows the planner to specify client density and throughput requirements, which are crucial for determining the correct number of APs.

In a mobility group design, it is essential that all Wireless LAN Controllers (WLCs) share the same mobility domain name to ensure seamless client mobility and roaming between WLCs. This allows for clients to be recognized across the network and maintain their sessions as they roam. Additionally, when WLCs are in a Stateful Switch Over (SSO) high availability pair, they must use the same virtual IP address to present a single network entity to the wireless clients, ensuring uninterrupted service in the event of a failover.