Black Friday Reward - Upto 75% off - Ends in 0d 00h 00m 00s - Coupon code: CFsave75

Pass the HP Aruba Certified Switching Expert HPE7-A10 Questions and answers with CertsForce

Viewing page 3 out of 3 pages
Viewing questions 21-30 out of questions
Questions # 21:

A customer has an HPE Aruba Networking ClearPass cluster. The customer has AOS-CX switches that use 802.1X authentication with HPE Aruba Networking ClearPass Policy Manager (CPPM).

The switches use local port-access policies. The customer wants to begin tunneling wired clients that pass user authentication only to an HPE Aruba Networking gateway cluster. The gateway cluster must assign these clients the eth-internet role. The gateway must also assign the clients to VLAN 20.

The planned enforcement policy and profiles are shown below:

* Policy: `written-exam-3`

* Profile: `written-exam-b`

The gateway cluster contains two gateways with these IP addresses:

Gateway 1: VLAN 4085 (system IP) = 10.20.4.21 | VLAN 20 (users) = 10.20.20.1 | VLAN 4094 (WAN) = 198.51.100.14

Gateway 2: VLAN 4085 (system IP) = 10.20.4.22 | VLAN 20 (users) = 10.20.20.2 | VLAN 4094 (WAN) = 198.51.100.12 | VRRP on VLAN 20 = 10.20.20.254

The customer requires high availability for tunnels between the switches and the gateway cluster. If one gateway fails, the other gateway must take over its tunnels. The switch must also be able to discover the gateway cluster whether either gateway is in the cluster.

Refer to the scenario.

What is one change that should be made to the solution?

Options:

A.

Remove VLAN assignments from role configurations on the gateways.


B.

Configure edge ports in VLAN trunk mode.


C.

Configure the UBT solution to use VLAN extend mode.


D.

Change the ubt-client-vlan to VLAN 13.


Expert Solution
Questions # 22:

A customer’s administrators have added RF Protect licenses and enabled WIDS for an AOS-8-based solution. The customer wants to use the APs’ built-in capabilities without deploying dedicated air monitors (AMs). Administrators tested rogue-AP detection by connecting an unauthorized wireless AP to a switch, but the rogue AP was still not detected after several hours.

What is one point you should ask about?

Options:

A.

Whether admins enabled wireless containment


B.

Whether the customer is using non-standard Wi-Fi channels in the deployment


C.

Whether admins set at least one radio on each AP to air monitor mode


D.

Whether APs' switch ports support all the VLANs that are accessible at the edge


Expert Solution
Viewing page 3 out of 3 pages
Viewing questions 21-30 out of questions