A BIG-IP Administrator is setting up a new BIG-IP device. The network administrator reports that the interface has an incompatible media speed. The BIG-IP Administrator needs to change this setting
manually.
From which location should the BIG-IP Administrator perform this task?
Refer to the exhibit.
How are new connections load balanced?
A BIG-IP device sends out the following SNMP trap:
big-ipo.f5.com - bigipExternalLinkChange Link: 1.0 is DOWN
Where in the BIG-IP Configuration utility should the BIG-IP Administrator verify the current status of Link
1.0?
Assuming that systems are synchronized, which action could take place if the fail over cable is connected correctly and working properly, but the systems cannot communicate over the network due to external network
problems?
A Standard Virtual Server configured for an application reports poor network performance. This
application is accessed mainly from computers on the Internet.
What should the BIG-IP Administrator configure on the Virtual Server to achieve better network
performance?
Administrative user accounts have been defined on the remote LDAP server and are unable to log in to
the BIG-IP device.
Which log file should the BIG-IP Administrator check to find the related messages?
A BIG-IP device is configured with both an internal external and two Corporate VLANs. The virtual server
has SNAT enabled and is set to listen on all VLANs Auto Last Hop is disabled. The Corporate users are on
10.0.0.0./24 and 172.16.0.0/12. The BIG-IP has a Self-IP on the 1.0.0.0.0./24 subnet.
Internet users are able to access the virtual server. Only some of the Corporate users are able to connect
to the virtual server A BIG-IP Administrator performs a tcpdump on the BIG-IP and verifies that traffic is
arriving from users in 10.0.0.0/24.
What should the BIG-IP Administrator do to correct this behaviour?
When network failover is enabled, which of the following is true?
New Syslog servers have been deployed in an organization. The BIG-IP Administrator must reconfigure the BIG-IP system to send log messages to these servers.
In which location in the Configuration Utility can the BIG-IP Administrator make the needed configuration changes to accomplish this?
Which two can be a part of a virtual server's definition? (Choose two.)
