Refer to the exhibit.
A customer is moving some VMAX devices under a VPLEX Local and is using PowerPath as multipath software. What is the preferred PowerPath load balancing policy assigned to VPLEX volumes?
After registering Cluster-2 with ESRS during a VPLEX Metro cluster build, what is the next step to perform before the cluster is successfully built?
Which command can provide information on connections between storage volumes and back-end ports?
A new VPLEX cluster has been configured. However, you are unable to register any host initiators. After verifying that the host has been properly zoned to the VPLEX cluster, you still cannot register them. What is a possible cause?
According to EMC best practices, how many metadata volumes for a VPLEX Metro configuration are required on each cluster?
Refer to the exhibit.
A customer needs to provision storage to a host on Cluster 1, but there is no additional local array capacity to allocate. How could the customer facilitate assigning storage to the Cluster 1 host from an array locally connected to Cluster 2?
An EMC customer wants to add a mirror to a VPLEX Local RAID 0 device. Which RAID type is created after the device attach-mirror command is issued?
When configuring a RAID-1 logging volume, what flags must be used in the command line?
medium-sized VPLEX clusters are connected via IP with a round-trip latency of approximately 35 ms.
What type of configuration is this?
When configuring a VPLEX local cluster, according to EMC best practices, how many metadata volumes are required?
