A platform engineer has created a cluster of 8 F200 nodes. A requirement is for each power supply on each node to supply power to the respective node equally.
What must the platform engineer do to meet the requirement?
A.
Run the isi config and change the settings in the config subsystem
B.
Cable each node power connection to a different PDU in the rack
C.
Use the iDRAC settings on each node to disable the hot spare feature
D.
Run the isi set -n command to change the power supply behavior
By default, the Power Supply Hot Spare feature may cause one power supply to run while the other is idle.
Steps to Ensure Equal Power Supply Loading:
Access iDRAC Interface:
Log into the iDRAC for each F200 node.
Disable Hot Spare Feature:
Navigate to Power Management settings.
Disable the Power Supply Hot Spare option.
Result:
Both power supplies will share the load equally.
Dell PowerScale References:
Dell EMC PowerScale F200 Hardware Guide:
Power Supply Configuration:
Instructions on adjusting power supply settings via iDRAC.
Best Practices:
Ensure redundancy by connecting power supplies to separate PDUs.
Monitor power usage to confirm balanced loading.
Contribute your Thoughts:
Chosen Answer:
This is a voting comment (?). You can switch to a simple comment. It is better to Upvote an existing comment if you don't have anything to add.
Submit