When a platform engineer connects to a Dell PowerScale F600 node using a serial connection and the session is unresponsive, the first action should be tocheck the settings of the serial connection. Serial communication requires specific configuration parameters to establish a successful connection. An incorrect setting can result in an unresponsive session.
The standard serial connection settings for Dell PowerScale nodes are:
Baud Rate:115200
Data Bits:8
Parity:None
Stop Bits:1
Flow Control:None
Steps to resolve the issue:
Verify Serial Port Configuration:
Open your terminal emulator software (e.g., PuTTY, Tera Term).
Check that the serial port settings match the required parameters.
Confirm Physical Connections:
Ensure that the serial cable is securely connected to both the laptop and the node's serial port.
Test the Serial Cable:
If possible, test the cable with another device to rule out a faulty cable.
Restarting the server or updating firmware is unnecessary at this stage and could introduce additional issues. Replacing the serial cable should only be considered after confirming that the settings and connections are correct.
References:
Dell PowerScale Hardware Installation and Planning Guide– Serial Connection Settings
Dell PowerScale OneFS CLI Administration Guide– Accessing the Cluster Through a Serial Connection
Dell Knowledge Base Article– Troubleshooting Serial Console Access
Contribute your Thoughts:
Chosen Answer:
This is a voting comment (?). You can switch to a simple comment. It is better to Upvote an existing comment if you don't have anything to add.
Submit