The correct answer is D. Replace the failed drive.
RAID 6 is a redundant array of independent disks that can tolerate up to two drive failures while still maintaining data integrity. According to CompTIA A+ Core 1 (220-1201) objectives, a red LED on a drive in a RAID array indicates that the drive has failed or is in a critical state.
Next Step: In RAID 6, a single failed drive should be replaced immediately to prevent additional failures and maintain redundancy. The array can continue to operate in a degraded state, but performance may be slow during rebuilds. Replacing the failed drive allows the RAID controller to rebuild data onto the new drive, restoring full redundancy.
Why the other options are incorrect:
A. Reconfigure the RAID array: This would erase existing data; unnecessary if only one drive failed.
B. Run a S.M.A.R.T. test: While useful for diagnosing drive health, the red LED already indicates failure, so immediate replacement is required.
C. Reinstall the controller drivers: This does not address a physically failed drive and would not fix the degraded RAID array.
[References:, CompTIA A+ Core 1 (220-1201) Exam Objectives – Hardware: “Given a scenario, troubleshoot storage and RAID issues including failed drives and degraded arrays.”, Mike Meyers’ CompTIA A+ Certification Guide, 13th Edition, Chapter on Storage Devices and RAID., , , , , , , , , ]
Submit