Pass the CWNP CWT - Certified Wireless Technician CWT-100 Questions and answers with CertsForce

Viewing page 2 out of 2 pages
Viewing questions 11-20 out of questions
Questions # 11:

Of the following device types, which one is most likely to be used in a highly mobile (use while in motion) use

case?

Options:

A.

Desktop


B.

Video camera


C.

VoIP handset


D.

Laptop


Expert Solution
Questions # 12:

When three APs are placed within ten meters of each other and use the same channel, but are not Single

Channel Architecture (SCA) APs, what problem will be exaggerated?

Options:

A.

Non-Wi-Fi interference


B.

Antenna misalignment


C.

ACI


D.

CCI


Expert Solution
Questions # 13:

How many non-overlapping 20 MHz channels are available in the 5 GHz frequency band assuming the

regulatory domain allows them all?

Options:

A.

11


B.

25


C.

24


D.

14


Expert Solution
Questions # 14:

What is entered on the AP and clients to configure WPA2-Personal?

Options:

A.

A passphrase


B.

The IP address of the RADIUS server


C.

The actual preshared key


D.

The WEP key


Expert Solution
Questions # 15:

You have enabled 802.11 standard Fast BSS Transition on your WLAN. Opportunistic Key Caching was

previously used. Now several VoIP handsets are dropping calls during roaming. What is the best solution?

Options:

A.

Install more APs


B.

Re-enable OKC


C.

Disable all roaming solutions


D.

Use WPA2-Personal instead


Expert Solution
Questions # 16:

You are using 802.1X/EAP for enterprise authentication for your WLAN. Where must the RADIUS server’s IP

address be configured to enable this for the WLAN?

Options:

A.

Wireless desktops


B.

Subnet router


C.

Wireless laptops


D.

AP


Expert Solution
Questions # 17:

What metric is most commonly used at the receiver to report the signal strength?

Select one:

Options:

A.

dBm


B.

Watt


C.

Milliwatt


D.

Nanowatt


Expert Solution
Questions # 18:

In what way are 802.11 channels defined?

Options:

A.

By a high frequency and channel width


B.

By channel width alone


C.

By a center frequency and channel width


D.

By a low frequency and channel width


Expert Solution
Viewing page 2 out of 2 pages
Viewing questions 11-20 out of questions