What is design considerations of policy-based routing?
A customer requests that you determine how much of their remote branch traffic into a central data center is related to a call manager that resides in the data center. Which solution do you recommend?
When designing fast convergence on a network using loop-free alternate, on which two basis can the next-hop routes be precomputed? (Choose two)
A network has several routers running IS-IS L1L2 mode on the same Ethernet segment. Which action reduces to a minimum the number of IS-IS adjacencies in this segment?
Refer to the exhibit.
Which routing solution is the most scalable to connect the branches to the HQ and to connect the branches together over the internet using DMVPN?
Refer to the exhibit.
A customer currently has a large EIGRP-based network with several remote sites attached. All remote sites connect to the two corporate data centers, depicted as 10.1.1.0 and 10.1.2.0. The customer has experienced several network-wide failures where neighbors were stuck-in-active and had other network stability issues due to some links flapping. Which two redesign options increase stability and reduce the load on the remote site routers, still maintaining optimal routing between remote sites and the two data centers? (Choose two)
Which two options are considered risks or concerns when both the Internet and VPN service functions are on the same PE router? (Choose two.)
Refer to the exhibit.
The operations team has identified that some of the multi-tiered e-commerce application have slow performance, due to illegitimate inbound traffic form the internet. On which device do you place traffic filtering to improve performance?
Refer to the exhibit.
An enterprise has three sites over a Layer 2 Metro Ethernet ELAN service. 100Mb/s and 10 Mb/s links have been provisioned to provide redundancy for the head office. When OSPF routing enabled to provide connectivity and the correct bandwidth statement has been applied to each interface, the branch sites observe two equal-cost routes to the head office. The enterprise wants to send all traffic through the 100 Mb/s link and use the 10Mb/S link strictly as a backup. Which OSPF network type must be set to ensure that the head office 100 Mb/s circuit is preferred over the 10 Mb/s circuit, at the same time minimize the amount of configuration required on all of the routers throughout the network?
Which MPLS attribute is required for links to carry a given MPLSTE tunnel?
