An engineer uses the standard local route group to configure call routing for the organization. The engineer configured an additional local route group with a unique name.
Which action must be taken to ensure that each device in the system is provisioned to know its local route group?
A customer routes PSTN calls to ITSP through a SIP trunk on Cisco UCM that forwards and receives calls to and from ITSP. ITSP is set to send an E.164 number when the customer's extension is four digits. Which action should be taken to route the incoming calls to four-digit extensions?
Refer to the exhibit.
The Cisco UCM is configured with four route patterns. When phone A dials 1515, which pattern does Cisco UCM choose as the correct match?
After configuring a Cisco CallManager Express with Cisco Unity Express, inbound calls from the PSTN SIP trunk receive a ring tone for 20 seconds and then a busy signal instead of voicemail. Which configuration fixes this problem?
What is first preference condition matched in a SIP-enabled incoming dial peer?
Refer to the exhibit.
A company needs to ensure that all calls are normalized to ♦ E164 format. Which configuration will ensure that the resulting digit string ♦14085554001 is created and will be routed to the E.164 routing schema?
An administrator has a requirement that the agents that receive calls from PSTN now must have a queue to hold the calls until they can be answered, but the customer cannot afford a contact center solution. The administrator discovered a feature called Native Call Queueing on Cisco UCM. Where must the administrator configure Native Call Queueing functionality?
What are the elements for Device Mobility configuration?
Refer to the exhibit. An engineer configured Call Admission Control on Cisco Unified Border Element to reject SIP calls when the aggregate bandwidth that is required for the calls exceeds the threshold. However, users complain of dropped calls when they place calls on hold during peak periods.
Which solution resolves this challenge?
An administrator is troubleshooting call failures on an H.323 gateway via the CLI. To see signaling for media and call setup, which debug must the Administrator turn on?
