Refer to the exhibit.
What is the relationship between Router 1 and Router 2?
Refer to the exhibit.
All backbone interfaces on the network are in VRF_MPLS and ip rsvp signalling hello is preconfigured on all MPLS routers in the network. After router R2 is upgraded and its configuration restored from backup. LSP signaled via RSVP that the tunnel from R1 had been tom down The network engineer confirmed IP reachability line the backbone network Which action must the engineer take to fix the issue?
Which type of BGP attribute does a route reflector attach to routes learned from iBGP peers that allows them to be accepted by other iBGP peers, thereby eliminating the need for a full-mesh BGP topology?
Refer to the exhibit.
Early in the growth cycle of a small enterprise the network-engineering team implemented segment routing to support automation of the IPv4 network As the network grew organically more devices were added and the company migrated to SRv6 The company is now planning to significantly expand the number of hosts connected to R2 and R6 which will require further path manipulation Which action must the team take to customize the route that traffic takes between endpoints in the network?
Refer to the exhibit.
Which effect of this configuration is true?
Refer to the exhibit.
An engineer applied the configuration on R1 to prevent network 192.168.1.0/24 from being propagated outside of area 5. After the change, users have reported they are not able to access any of the application servers that were working before. While checking the routing table of the peer router. The engineer notices R1 stopped propagating any routes outside are 5. Which action must be taken to fix the problem?
Refer to the exhibit. A network engineer must correct the security policy on the EDGE_R router, which is connected to two Tier 1 ISPs. After another engineer added ip as-path access-list 11 permit 11 to EDGE_R, some routes from AS 11 and AS 4832 started to appear in the routing information base (RIB). Traffic control via Community options is disabled on both ISPs. How should the network engineer update the router configuration on EDGE_R so that only routes for AS 11 are permitted?
What is the purpose of a BGP confederation?
Refer to the exhibit.
Router 1. Router 2. and Router 3 are co-located in an onsite data center of an office, but Router 4. Router 5. and Router 6 are installed in another data center 'eral miles away. A network engineer is troubleshooting an RSVP-TE issue on the network. On most of the devices, the engineer can move all LSPs away from a selected dace and take it down for maintenance without interrupting traffic. However, when an interface on Router 3 is taken down, traffic on the network is disrupted. What must the engineer enable to resolve the issue on Router 3?
After you change the IP address on an IOS XR router, you cannot ping the new address.
Which step did you forget to complete?
