Pass the BICSI RCDD Certification RCDD-002 Questions and answers with CertsForce

Viewing page 9 out of 11 pages
Viewing questions 81-90 out of questions
Questions # 81:

What element is typically NOT part of a paging system?

Options:

A.

Strobe


B.

Distribution


C.

Amplification


D.

Loudspeakers


Expert Solution
Questions # 82:

A space has all hard surfaces including architecture and furnishings. The audio programming produced from the distributed sound system has become unintelligible. Which of the following will NOT mitigate the problem?

Options:

A.

Add tapestries to the walls.


B.

Provide additional speakers at lower output.


C.

Increase the volume to the existing speakers.


D.

Reduce the distance of the existing speakers to the listener.


Expert Solution
Questions # 83:

Using the sound pressure level (SPL) method of approximating distance and power, calculate the power required to produce 89 dB at 4 m (13.1 ft) with a loud speaker that is rated at a SPL of 95 dB. What input power level (in watts) is required to appropriately power the speaker?

Options:

A.

1 watt


B.

2 watts


C.

4 watts


D.

8 watts


Expert Solution
Questions # 84:

What are the three typical voltages used in centrally amplified paging systems?

Options:

A.

24, 48, and 90


B.

25, 70, and 100


C.

25, 90, and 120


D.

48, 90, and 120


Expert Solution
Questions # 85:

What is the recommended distance between ceiling mounted speakers in a hallway with heavy traffic?

Options:

A.

2.4 m (8 ft)


B.

3.7 m (12 ft)


C.

4.9 m (16 ft)


D.

6 m (20 ft)


Expert Solution
Questions # 86:

When installing outlet boxes in ten private offices in an area which may prove to be difficult to install future additional telecommunications outlets, the MINIMUM quantity of outlet boxes that should be installed is:

Options:

A.

10


B.

20


C.

30


D.

Based on the type of cabling specified


Expert Solution
Questions # 87:

In a run requiring 15 m (50 ft) of cable between the floor distributor and the consolidation point, the MAXIMUM length of cable allowed between the CP and the telecommunications outlet is:

Options:

A.

27.4 m (90 ft)


B.

36.5 m (120 ft)


C.

45.8 m (150 ft)


D.

75 m (242 ft)


E.

90 m (295 ft)


Expert Solution
Questions # 88:

Assuming the total fill capacity of a pathway is 100 cables (all of the same cable type and size), the MAXIMUM number of cables to be installed during the initial installation, without exceeding the fill ratio is:

Options:

A.

25


B.

40


C.

50


D.

60


Expert Solution
Questions # 89:

A telecommunications outlet/connector may be provided using all listed below EXCEPT:

Options:

A.

Wireless AP connectivity


B.

Balanced twisted-pair outlets


C.

Optical fiber connectors


D.

4p4c (4 position, 4 contact) connector


Expert Solution
Questions # 90:

An open office design is made up of three furniture clusters and contains a total of nine. How many multiuser telecommunications outlet assemblies (MUTOA) should be in the design?

Options:

A.

1


B.

3


C.

4


D.

6


E.

9


Expert Solution
Viewing page 9 out of 11 pages
Viewing questions 81-90 out of questions