Pass the VMware VCAP-NV Design 2020 3V0-42.20 Questions and answers with CertsForce

Viewing page 2 out of 2 pages
Viewing questions 11-20 out of questions
Questions # 11:

Which two resources can be used by an NSX architect during the Assessment Phase? (Choose two.)

Options:

A.

vRealize Network Insight


B.

VMware Validated Design


C.

VMware customer references


D.

key stakeholder interviews


E.

application licensing


Expert Solution
Questions # 12:

Which type of design includes vendor models, host names, IP Addresses, port connections, logical unit number sizes, and number of CPUs? (Choose the best answer.)

Options:

A.

Physical Design


B.

Conceptual Design


C.

High-Level Design


D.

Logical Design


Expert Solution
Questions # 13:

An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.This information was gathered during the Assessment Phase:

    Maximum performance and availability is required between the physical and virtual network.

    Load Balancing service is required for back-end web servers.

    NAT is required.

Which selection should the architect include in their design? (Choose the best answer.)

Options:

A.

Deploy a Tier-1 gateway and connect it to an Active/Active Tier-0 gateway with ECMP configured.


B.

Deploy an Active/Active Tier-0 gateway and configure ECMP.


C.

Deploy an Active/Standby Tier-0 gateway and configure ECMP.


D.

Create two separate VLANs to connect the Tier-0 gateway upstream traffic and configure ECMP.


Expert Solution
Questions # 14:

An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.This information was gathered during a workshop about ESXi Host networking:

    A total of 50 ESXi hosts to be configured as Transport Nodes.

    All ESXi hosts have a dedicated 2 × Intel 10Gbps Physical Network adapter for the Overlay Traffic.

To achieve low latency, high throughput, redundancy, and performance, which two NIC teaming policies should the architect recommend? (Choose two.)

Options:

A.

Load Balance Source MAC


B.

Load Balance Port ID


C.

Load Balance Source


D.

Load Balance Source Port ID


E.

Failover Order


Expert Solution
Questions # 15:

Which three choices are non-functional requirements? (Choose three.)

Options:

A.

authorization


B.

certification


C.

availability


D.

authentication


E.

scalability


F.

cost


Expert Solution
Questions # 16:

An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.This information was gathered during the Assessment Phase:

    There isn’t much budget available for a new off shore site.

    The new site is decentralized and no communication with the main data center is required.

    The design will need to cater for availability, upgrades, and failure scenarios.

    N+1 must be maintained at all times.

Which three selections should the architect recommend in their design? (Choose three.)

Options:

A.

Separate the hosts physical NICs for VSS and N-VDS.


B.

Make all pNICs part of N-VDS and VMKs will be migrated.


C.

Collapse the Management/Edge/Compute cluster.


D.

Install a minimum 4 ESXi hosts in the site.


E.

A Shared Edge/Management cluster and one for Compute.


F.

Install a minimum of 3 ESXi hosts in the site.


Expert Solution
Questions # 17:

An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.

This information was gathered during the Assessment Phase:

    There is a critical application used by the Finance Team.

    The critical application has an availability and recoverability SLA of 99.999%.

    The critical application is sensitive to network changes.

Which two selections should an architect include in their design? (Choose two.)

Options:

A.

Configure Tier-0 gateway for eBGP and ECMP.


B.

Configure Tier-1 gateway for eBGP and ECMP.


C.

Enable BFD on Tier-0 gateway.


D.

Install and configure hosts with 100Gbps physical NICs.


E.

Configure multiple static routes on Tier-1 gateway.


Expert Solution
Viewing page 2 out of 2 pages
Viewing questions 11-20 out of questions