A new storage shelf is added to an existing appliance.
Which command under Manage > Storage must the administrator perform first after a new shelf is connected to the appliance and the appliance is powered on?
When powering an appliance on, it fails to complete the Power On Self Test (POST).
Which two monitoring tools should the administrator use to gather information regarding the problem? (Select two.)
Which feature is enabled after adding a master server to the Trusted Master Servers tab?
A NetBackup master server has commenced writing four long-running duplication jobs to an AdvancedDisk disk pool. The value of Maximum concurrent jobs for the storage unit and Limit I/O streams for the disk pool are both set to 4.
There are 35 jobs queued on the master server that require this disk pool:
5 replication jobs with priority 9999
10 backup jobs with priority 999
20 duplication jobs with priority 99
Two restore jobs that require this disk pool are then submitted with a default priority.
Which job type goes active next?
An administrator has a scheduled policy that backs up 20 clients, each with multiple mount points and multiple data streams enabled. One of the jobs has failed and is in an Incomplete state in the Activity Monitor.
How should the administrator verify the incomplete job runs prior to the next scheduled backup?
A backup image on tape is due to expire in one week. The administrator needs to keep the image available for restore indefinitely.
Which two methods can be used to accomplish this goal? (Select two.)
An administrator has a backup policy with the following policy attributes:
3 paths listed in the Backup Selections list
5 clients listed in the Clients list
Allow multiple data streams is selected
Limit jobs per policy is set to 4
How many jobs go Active when the job is started, excluding parent jobs, assuming there are enough storage resources to handle the expected jobs?
Which event can cause a NetBackup appliance to proactively shut down?
NetBackup has frozen some of the tapes added to the robot.
Which log must be enabled to determine why the tapes were frozen?
An administrator is attempting to configure a new backup policy using synthetic backups. When creating a new full backup schedule, the Synthetic backup option is unable to be selected.
What must the administrator do to the policy to make the Synthetic backup option available for selection?
