Refer to the exhibit.
Based on the exhibit, What can be definitively determined about host DEMO-AHV-2
An administrator is using Nutanix Move to migrate a Windows VM from ESXi to AHV. Automated guest preparation is failing with an error:
Account has UAC enabled error
The administrator is using the local built-in administrator account for the Windows VM Admin approval mode must remain enabled.
What should the administrator do to continue with the migration with Nutanix Move?
An administrator needs to take a single node down for maintenance. Which two steps should the administrator take? (Choose two)
Which command should an administrator run from the CLI to view the uplink state of all AHV nodes in the cluster?
An administrator has a custom backup application that requires a 2TB disk and runs in Windows. Throughput is considerably lower than expected.
The application was installed on a VM with the following configuration:
• Four vCPUs with one core/vCPU
• 4GB of Memory
• One 50GB vDisk for the Windows installation
• One 2TB vDisk for the application
What is the recommended configuration change to improve throughput?
An administrator is updating disk firmware using LCM and receives the following message:
“there have been 10 or more cluster services restarts within 15 minutes in the Controller VM”
The message appears as each drive is upgraded.
What is the reason this message is being generated?
An administrator is configuring software only. Data-at-Rest Encryption on their Nutanix cluster. They are planning to deploy a third-party key management server (KMS).
Where should this server be hosted?
An administrator needs to determine current CPU usage across multiple clusters.
Which method should the administrator use to generate this type of report?
Nutanix Support Asked an administrator to provide AHV logs to help solve a support request.
Which task should be performed to provide log files to the support team?
A customer recently set up Async Replication between Site A and Site B. The customer wants to conduct a planned failover and clicks Activate on Site B.
The customer then runs the following command on Site A:
ncli pd deactivate_and__destroy_vms name=
What does this do to the customer environment?
