Pass the NICET Inspection and Testing of Fire Alarm Systems ITFAS-Level-1 Questions and answers with CertsForce

NFPA 72 requires strict identification and protection of theprimary power supplycircuit to the fire alarm control unit (FACU) to prevent unauthorized disconnection.

NFPA 72 (2022), Section 10.6.5.2.1:

"The circuit disconnecting means shall be identified as 'FIRE ALARM CIRCUIT' at the point of disconnect and at the fire alarm control unit."

Section 10.6.5.2.2:

"A circuit breaker used as the disconnecting means shall be protected from unauthorized operation by a locking device."

There isno requirementfor the locking device to be labeled — it only must be installed.

Correct answers:

The system circuit disconnect shall be permanently identified as "Fire Alarm."

The system circuit disconnect shall be permanently identified at the control unit.

Where a circuit breaker is the disconnecting means, a breaker locking device shall be installed.

===========

When aDACTis the only method of off-premises signal transmission, itmustbe connected totwo separate telephone linesto ensure redundancy in case one line fails.

NFPA 72 (2022), Section 26.6.4.4.4.1:

“DACTs shall be connected to two separate phone lines (one primary, one secondary). Loss of the primary line shall result in a supervisory signal.”

This redundancy ensures system reliability when using traditional telephone-based communication.

Correct answer: D. Two separate phone lines are required

===========

NFPA 72 identifies severaltypes of fire alarm control units (FACUs)based on their function and scope.

NFPA 72 (2022), Section 3.3.103 — Fire Alarm Control Unit (FACU):

Dedicated Function FACU: Performs a specific fire alarm role (e.g., elevator recall or sprinkler monitoring).

Protected Premises FACU: Installed on-site to monitor and signal within that building.

Releasing Service FACU: Activates fire suppression systems like gas or foam.

"Central station" is asupervising station, not a control unit.

Correct answers:

Dedicated function

Protected premises

Releasing service

===========

The need toclean devicessuch as detectors is influenced by theenvironment they are installed in, not just their type or age. Dusty, smoky, or humid environments will require more frequent cleaning.

NFPA 72 (2022), Section 14.4.1.3:

“The frequency of cleaning shall be determined by the manufacturer’s instructions and the local ambient conditions.”

Correct answer: C. Local ambient conditions

===========

Signal priorities determine the order in which events are processed and displayed by the fire alarm system.

NFPA 72 (2022), Annex A.10.14.3 and system programming guidelines:

While not directly listed in a table, systems are programmed such that:

Alarm (including pre-alarm)has the highest priority

Followed bysupervisory, thentrouble, and finallyrestoral

Pre-alarm is part ofalarm initiation logicand is treated as high-priority due to its potential escalation.

Correct answer: A. Pre-alarm

===========