What should a restorer do when there is contamination (e.g., Category 2, Category 3, Mold) on a water damage restoration project to protect workers and occupants?
A.
Wipe down the contamination with detergent cleaner
B.
Call the insurance company and discuss costs
C.
Fog a water-based disinfectant into the affected area
D.
Use appropriate PPE, containment, or other engineering controls
The IICRC WRT body of knowledge emphasizes that when contamination is present, the restorer’s responsibility is toprotect workers and occupantsby implementing appropriate controls. This includes the use ofpersonal protective equipment (PPE),containment systems, andengineering or administrative controlsas dictated by the hazard assessment.
Category 2 and Category 3 water, as well as mold-contaminated environments, can expose individuals to microorganisms, allergens, and other harmful agents. The WRT manual reinforces the hierarchy of controls: eliminate hazards when possible, isolate hazards through containment, and protect workers with PPE when hazards cannot be fully removed.
Fogging disinfectants or wiping surfaces does not eliminate airborne or surface hazards and may actually increase aerosolization if done improperly. Contacting the insurance company is an administrative step and does not mitigate health risks.
The WRT curriculum also aligns with OSHA principles, stressing that safety controls must be implementedbeforeandduringrestoration activities. Proper containment and PPE selection are essential to prevent cross-contamination and protect both restoration personnel and building occupants.
Contribute your Thoughts:
Chosen Answer:
This is a voting comment (?). You can switch to a simple comment. It is better to Upvote an existing comment if you don't have anything to add.
Submit