All four conditions can prevent a UE from generating or transmitting a valid B1 measurement report during Non-Standalone (NSA) E-UTRA–NR Dual Connectivity (EN-DC) access.
In NSA architecture, the LTE eNodeB acts as the Master Node and configures NR inter-RAT measurements to determine whether an eligible 5G NR cell can be added as a Secondary Node.
Event B1 is triggered when the measured quality of an inter-RAT neighboring cell exceeds the configured threshold, subject to hysteresis and time-to-trigger requirements.
Option A: Excessive received signal power may saturate the UE receiver, degrading synchronization-signal detection and preventing successful NR cell measurements.
Option B: If the LTE-side measurement configuration identifies a frequency that does not correspond to the intended NR SSB carrier, the UE may be unable to detect the target NR synchronization signals.
Option C: If the measured NR signal does not satisfy the configured B1 entry condition, the reporting event is not triggered.
Option D: An abnormal NR cell may fail to transmit the required synchronization signals correctly or provide measurable radio coverage, preventing a valid measurement result.
Therefore, all four conditions are plausible causes of missing B1 measurement reports.
Official Reference: 3GPP TS 36.331, Inter-RAT Measurement Reporting — Event B1 ; TS 38.533, Section 8.4.2, NR Inter-RAT Event-Triggered Reporting Requirements .
Submit