Block Error Rate (BLER) is the intended answer because outer-loop power-control algorithms use error-performance feedback to adjust the target received signal quality required for reliable control-channel reception.
PUCCH carries essential Uplink Control Information (UCI), including HARQ acknowledgments, scheduling requests, and configured channel-state reports.
Errors in these transmissions can produce unnecessary retransmissions, incorrect scheduling decisions, and reduced radio-network efficiency.
The distinction between inner-loop and outer-loop power control is important.
Inner-loop power control adjusts transmission power according to the difference between measured signal quality, commonly expressed through SINR, and a configured target.
The gNodeB can issue Transmit Power Control (TPC) commands to modify the UE's PUCCH transmit power.
Outer-loop power control adjusts the target signal-quality requirement according to observed error performance. When reception reliability deteriorates, the target SINR can be increased to improve decoding probability. Conversely, consistently satisfactory error performance can permit a reduction in the target.
RSRP measures received reference-signal power, while power spectral density expresses signal or noise power per unit bandwidth. Neither directly represents the error-performance feedback used in the intended outer-loop mechanism.
Therefore, BLER is the expected examination answer, with implementation-specific qualifications.
Official Reference: 3GPP TS 38.213, Section 7.2.1, PUCCH Transmit Power Control .
Technical warning / qualification: 3GPP specifies the PUCCH power-control signaling and calculations but does not mandate one universal BLER-based outer-loop algorithm. Huawei implementations may use BER or another error-performance measure depending on the radio technology and PUCCH configuration.
Submit