You have copied a new Net-Net OS to the Net-Net 4000 and changed the boot parameters according to the display below. On reboot, the Net-Net 4000 is in a boot loop.

training1# check-space-remaining boot boot:

0/29702144 bytes (0%) remaining

training1# configure terminal

training1(configure)# bootparam

'.' = clear field; '-' = go to previous field; q = quit

boot device : wancom0

processor number : 0

host name :

file name : /tffs0/sd200p23.gz /tffs0/sd400q10.gz

inet on ethernet (e) : 10.0.3.11:ffff0000

inet on backplane (b) :

host inet (h) : 10.0.3.1

gateway inet (g) : 10.0.0.1

user (u) : anonymous

ftp password (pw) (blank = use rsh) : anonymous

flags (f) : 0x80008

target name (tn) : training1

startup script (s) :

other (o) :

NOTE: These changed parameters will not go into effect until reboot. Also, be aware that some boot parameters may also be changed through PHY and Network Interface Configurations.

training1(configure)# exit

training1# reboot force

Based on the information above, which three of the following scenarios could be the cause of the boot loop?