Pass the Acme Packet Acme Packet Certifications AP0-001 Questions and answers with CertsForce

Viewing page 1 out of 5 pages
Viewing questions 1-10 out of questions
Questions # 1:

When configuring the allow-anonymous parameter in the SIP port element, a value of __________ may be configured to allow access only from user agents who have previously registered through the Net-Net 4000 or who are configured as session agents.

Options:

A.

registered


B.

agents-only


C.

realm-prefix


D.

prev-registered


Questions # 2:

How does the Net-Net 4000 ensure that the pinholes are kept open for persistent communication to SIP endpoints behind a NAT device?

Options:

A.

By sending OPTIONS messages at a defined frequency


B.

By sending ARP requests at a defined frequency


C.

By changing the expires= parameter to a defined value in 200 OK responses to REGISTERs


D.

By changing the expires= parameter to a defined value in 200 OK responses to INVITEs


Questions # 3:

Steering pools are realm specific, and by limiting the number of __________ provide constraints on the number of concurrent RTP sessions allowed on the Net-Net 4000.

Options:

A.

UDP ports


B.

slots


C.

IP addresses


D.

Realms


Questions # 4:

In a high availability (HA) cluster, a network administrator could trigger a system switchover manually from the __________ Net-Net 4000 by issuing the notify berpd force command.

Options:

A.

Standby or Active


B.

Active only


C.

Standby only


D.

Active node that no longer has a heartbeat


Questions # 5:

In a high availability (HA) scenario, if peers boot simultaneously and their health scores are equivalent, which node automatically assumes the role of Active?

Options:

A.

The node that had the role of active last.


B.

The node that had the role of standby last.


C.

The node with the highest Wancom IP address.


D.

The node with the lowest Wancom IP address.


Questions # 6:

Which one of the following statements about the SIP-NAT is TRUE?

Options:

A.

The Net-Net 4000 uses the SIP-NAT element to rewrite the contact-URI, the Via header and the SDP.


B.

The Net-Net 4000 uses the SIP-NAT to provide translation between a home address space and an external address space.


C.

The Net-Net 4000 uses the SIP-NAT to act as a service pipe to SIPD.


D.

You must have at least one SIP-NAT to route traffic between realms.


Questions # 7:

Examine the output below from the network interface configuration.

Question # 7

When the Net-Net 4000 does not get an ARP response from the device configured as its gateway in the configured retry time period, it will____________.

Options:

A.

send traffic to the device configured in the sec-gateway field


B.

decrement its health score to 50 which may result in a failover to the standby


C.

use the Virtual Router Redundancy Protocol (VRRP) to determine a new default gateway


D.

use the Virtual Router Redundancy Protocol (VRRP) to the host(s) instead of the primary gateway


Questions # 8:

The __________ is software that controls the bootup.

Options:

A.

bootloader


B.

Net-Net OS


C.

Diagnostic Image


D.

nPsoft


Questions # 9:

When configuring the SIP interface for a realm, the __________ field indicates how often a User Agent (UA) located behind a NAT should reREGISTER with the Net-Net 4000.

Options:

A.

nat-interval


B.

nat-traversal


C.

registration-interval


D.

nat-mode


Questions # 10:

__________ is the Net-Net 4000 internal SIP proxy, responsible for processing the SIP header addressing information and passing the signaling to the egress realm

Options:

A.

Sipd


B.

Mbcd


C.

Algd


D.

Sipp


Viewing page 1 out of 5 pages
Viewing questions 1-10 out of questions