A WLAN transmitter that emits a 50 mW signal is connected to a cable with 3 dB loss. If the cable is connected to an antenna with 9dBi gain, what is the EIRP at the antenna element?
A client STA must choose the best AP for connectivity. As part of the evaluation, it must verify compatible data rates. What can the client STA use to verify that an AP supports the same data rates that it supports?
What security method is commonly used for VoIP handsets when the infrastructure does not support OKC or FT roaming?
When a client station sends a broadcast probe request frame with a wildcard SSID, how do APs respond?
You were previously onsite at XYZ’s facility to conduct a pre-deployment RF site survey. The WLAN has been deployed according to your recommendations and you are onsite again to perform a post-deployment validation survey.
When performing this type of post-deployment RF site survey voice over Wi-Fi, what is an action that must be performed?
You are installing AP to be used by 23 laptops. All laptops will connect on the 5 GHz frequency band. A neighbor network uses channels 1 and 6. What channel should be used for this AP and why?
An IEEE 802.11 amendment is in the daft state. What impact does this draft amendment have on the 802.11 standard?
What factor is likely to cause the least impact on the application layer throughput of an 802.11n client station in a 2.4 GHz HT BSS?
ABC Company is planning to install a new 802.11ac WLAN, but wants to upgrade its wired infrastructure first to provide the best user experience possible. ABC Company has hired you to perform the RF site survey. During the interview with the network manager, you are told that the new Ethernet edge switches will support VoIP phones and 802.11 access points, both using 802.3 PoE.
After hearing this information, what immediate concerns do you note?
The BSA of an AP covers the area used by the sales and marketing department. Thirty-five stations operate in this space. The users indicate that they need more throughput and all stations are 5 GHz capable 802.11ac clients. The current AP configuration uses 20 MHz channels in both 2.4 GHz and 5 GHz. What is the least expensive solution available for increasing throughput for these users without implementing configuration options that are not recommended?
