Switches and APs have already been chosen by your customer. All switches support 802.3bz MultiGig interfaces and APs are 4x4:4 802.11ac wave 2 capable of using dual-5GHz and have one MultiGig interface. Some cable drops for the APs will run for more than 180.5 feet (or 55 meters). To support MultiGig, what is the best choice of cabling?
When deploying APs outdoors, what additional component needs to be used that is not needed indoors?
During your first pre-deployment meeting with the deployment team, you hand out the full design documentation to all of them. What’s your primary goal during this meeting?
You are validating association capabilities from clients to an 802.1X/EAP secure SSID. The RADIUS server’s IP address is 10.100.50.25 and the default RADIUS authentication port is used. When testing them, none of the clients are able to associate to the SSID. Troubleshooting the WLAN infrastructure, you found out that the server is up and the RADIUS service is up as well, but the authenticator is not able to communicate properly with the server. What’s your next troubleshooting step?
When doing some frame capturing over the air during a voice call, you realized that frames on the downlink (from the AP to the client) direction are not being transmitted with the correct UP value for voice frames, but on the uplink (from the client to the AP) direction are being transmitted correctly. What’s the cause of this issue?
A museum wants to offer Wi-Fi to its visitors. One of their requirements is to have the APs blend into the design of the museum. What should you do to meet this requirement?
When performing an active site survey in an existing WLAN infrastructure, in addition to gathering throughput data, what other important function will you typically be testing at the same time?
A controller-based WLAN infrastructure has its controller on a different subnet than its APs. What device must be used to enable any communication between the Controller and the APs?
Your customer requires a security solution in which client credentials are used and the authentication server must have a certificate with optional client certificate use. Which EAP method would be the best fit for their requirement?
Your customer’s 802.11n laptops are not able to see the SSID in the 5 GHz band in the conference room. When doing a walkthrough using one of these laptops, you confirm that it is unable to see the SSID in the 5 GHz band in the conference room. When using your own 802.11 ac laptop, you’re able to see the SSID. What is the most likely cause of this problem?
