Pass the Cisco CCNP Enterprise 300-435 Questions and answers with CertsForce

The JSON formatted output from a network monitoring tool indicates that there is one unmonitored device in the access category. Additionally, the “healthScore” section shows values for “badCount” and “badPercentage” greater than zero, suggesting at least one device in this category has performance issues. Since this falls under the Access category, it can be inferred that an access switch is functioning in a degraded state. References: Automating Cisco Enterprise Solutions Official Cert Guide

The /dna/intent/api/v1/issues API request provides information about network issues detected by Cisco DNA Center.

It includes details about the issue, impacted hosts, and suggested actions for resolution.

References:

Cisco DevNet - Intent APIs

The difference between OpenConfig and native YANG data models lies in their development and purpose:

D: Native models are developed by vendors and are specific to their platforms. They are designed to integrate features or configurations that are relevant only to that vendor’s platform. Native models, being vendor-specific, provide the most detailed and granular control over the vendor’s devices1.

OpenConfig models, on the other hand, are developed by a collaborative group of network operators and are intended to be vendor-neutral. They aim to provide a more standardized model that can be used across different vendors’ equipment, focusing on the needs of the operators rather than the specific capabilities of the devices1.

References:

Cisco Blogs on YANG models1

CBT Nuggets on Native YANG models2

Introduction to YANG - LTRSDN-2260

To ensure that the consumer receives the telemetry data, it is crucial to define the destination where the telemetry data should be sent. This is accomplished by configuring the IP address of the receiver. Without this information, even if the Cisco IOS XE device accepts the configuration commands for a static telemetry subscription, it will not know the destination for the data, resulting in the consumer not receiving any telemetry data. References: Automating Cisco Enterprise Solutions Official Cert Guide

Python virtual environments are a tool used to create isolated Python environments, each with its own set of dependencies. This isolation is beneficial for several reasons:

D: Virtual environments allow developers to create a Python environment quickly for testing and debugging purposes. This is because each virtual environment can have its own set of dependencies, which may be different from those installed globally or in other virtual environments. This isolation helps ensure that the environment reflects the production environment as closely as possible, which is crucial for accurate testing and debugging12.

E: They enable the creation of an isolated Python environment with module dependencies. This means that the dependencies installed in a virtual environment do not affect the system-wide Python installation or other virtual environments. This isolation prevents conflicts between project dependencies and allows for more precise control over the environment in which your code runs12.

References:

Automating Cisco Enterprise Solutions Official Cert Guide

Real Python’s "Python Virtual Environments: A Primer"1

Dataquest’s "A Complete Guide to Python Virtual Environments"

 Native YANG models are specific to a vendor’s platform, incorporating proprietary features, whereas OpenConfig models are vendor-neutral and created for interoperable use across different platforms.

 To automate the creation of a network on the Meraki dashboard that supports only wired network connections, the type ‘switch’ needs to be added to the API. This is because ‘switch’ refers to network switches, which are hardware devices that connect devices on a computer network by using packet switching to receive, process, and forward data to the destination device. In contrast, ‘wireless’ would refer to Wi-Fi connections, ‘appliance’ could refer to security appliances or other types of network equipment not specifically related to wired connections, and ‘systemsManager’ is related to mobile device management. References := ( Automating Cisco Enterprise Solutions Official Cert Guide )