BICSI INSTC_V8 Exam Questions Free Practice Test

Viewing page 5 out of 5 pages

Viewing questions 41-50 out of questions

Questions # 41:

How far should the top of a ladder extend above the roofline?

Options:

0.3 m (1')

0.5 m (1.6')

0.6 m (2')

0.9 m (3')

Expert Solution

Questions # 42:

What is the specified performance level for Category 8 cable?

Options:

100 MHz

250 MHz

1000 MHz

2000 MHz

Expert Solution

Questions # 43:

If a horizontal cable is placed in an open ceiling return-air plenum, which cable rating is REQUIRED by NFPA and BICSI guidelines?

Options:

CMR

CMP

CATVX

Expert Solution

Questions # 44:

Which of the following describes a situation where a BICSI Installer 2 may have to calculate a cable’s derating factor?

Options:

When installing cables in plenum-rated air-handling spaces

When running cables in environments below -20°C (-4°F)

When bundling large numbers of cables together, impacting heat dissipation

When running cable vertically without any horizontal transitions

Expert Solution

Questions # 45:

Regarding safety protocols from the BICSI Installer 2 manual, which is the MOST important initial step before using a power puller for cable installation?

Options:

Ensuring the puller’s label matches the cable category

Verifying that all conduit runs are reamed and free of burrs

Conducting a thorough job hazard analysis (JHA) or risk assessment

Wearing a full-body harness, regardless of the installation height

Expert Solution

Questions # 46:

Which type of optical fiber cable should be color coded with an Orange outer cable sheath?

Options:

MM with a 100 um core diameter

Dispersion-shifted SM optical fiber

Polarization maintain SM optical fiber

SM optical fiber

Expert Solution

Questions # 47:

You are terminating a category 3 cable. What is the maximum permissible amount of untwisting?

Options:

25 mm (1")

38 mm (1.5")

75 mm (3")

100 mm (4")

Expert Solution

Questions # 48:

How much sheath of the cable needs to be removed in order to properly terminate an 8P8C?

Options:

6.3mm (0.25")

12.7mm (0.5")

25mm (1")

38 mm (1.5")

Expert Solution

Questions # 49:

What is the PRIMARY benefit of ensuring large bend radii when installing both copper and fiber cables?

Options:

It reduces the necessary pulling tension for the installation

It lowers overall cable cost by minimizing wasted cable

It decreases return loss and potential attenuation issues

It ensures compliance with jacket flame ratings

Expert Solution

Viewing page 5 out of 5 pages

Viewing questions 41-50 out of questions

Pass the BICSI Cabling Installation INSTC_V8 Questions and answers with CertsForce