Pass the BICSI DCDC Certification DCDC-002 Questions and answers with CertsForce

Viewing page 3 out of 5 pages
Viewing questions 21-30 out of questions
Questions # 21:

What is the maximum recommended number of racks in an aisle?

Options:

A.

20 racks


B.

10 racks


C.

30 racks


D.

40 racks


Expert Solution
Questions # 22:

why does the entrance room designer need to meet with each anticipated access provider?

Options:

A.

To determine their electrical, space, interface, and other facility requirements


B.

As an alternative approach to save cost


C.

To know about hardware requirement only


D.

none of above


Expert Solution
Questions # 23:

What is the minimum required headroom for overhead cable tray?

Options:

A.

3"


B.

6"


C.

9"


D.

12"


Expert Solution
Questions # 24:

What is recommended size ratio of Secure Storage Area?

Options:

A.

5% of Computer Room Space


B.

10% or greater than Available Floor Space


C.

15-20% more than Computer Room's Cross Sectional Area


D.

10% of Computer Room's Net Square Footage


E.

None Of These


Expert Solution
Questions # 25:

According to NEB, what is the recommended range for the low temperature in a data center?

Options:

A.

65 degrees


B.

60 degrees


C.

55 degrees


D.

70 degrees


E.

75 degrees


Expert Solution
Questions # 26:

What is the United States Average Power Utility Outage Annually And What Is The Average Repair Time?

Options:

A.

2.5 outages annually, with average repair time of approximately 7 hours


B.

1 outage annually, with average repair time of approximately eight hours


C.

1.86 outages annually, with average repair time of four hours


D.

Three outages annually, with an unknown average repair time


Expert Solution
Questions # 27:

What is the recommendation regarding row length?

Options:

A.

Do not exceed 20 racks in length and dead-end rows not to exceed ten racks long


B.

Maximum twenty-five racks in each row only


C.

Ten Racks in Length


D.

None


E.

All


Expert Solution
Questions # 28:

What is the formula to find the maximum allowable cable depth in a non-solid bottom cable tray?

Options:

A.

H = 50/1 + (L * 0.0007)


B.

H = 100/1 + (L * 0.0007)


C.

H = 150/1 + (L * 0.0007)


D.

H = 200/1 + (L * 0.0007)


Expert Solution
Questions # 29:

What is the minimum size conductor from the TMGB to the building main ground bus?

Options:

A.

80mm (150MCM) bare copper


B.

100mm (200MCM) bare copper


C.

130mm (250MCM) bare copper


D.

160mm (300MCM) bare copper


E.

200mm (400MCM) bare copper


Expert Solution
Questions # 30:

According to NEB, what is the recommended rate of temperature change per hour in a data center?

Options:

A.

36 degrees


B.

45 degrees


C.

54 degrees


D.

63 degrees


E.

72 degrees


Expert Solution
Viewing page 3 out of 5 pages
Viewing questions 21-30 out of questions