Black Friday Reward - Upto 75% off - Ends in 0d 00h 00m 00s - Coupon code: CFsave75

Pass the Huawei HCIE-Datacom H35-831 Questions and answers with CertsForce

Viewing page 1 out of 2 pages
Viewing questions 1-10 out of questions
Questions # 1:

In the transport network shown, two-level RRs are deployed, and RTA has the directly connected network segment 10.1.1.0/30. Which of the following statements about the BGP deployment solution are incorrect?

Question # 1

Exhibit 28.1 — Original topology/configuration figure

Options:

A.

To enable level-2 RRs to learn the route to network segment 10.1.1.0/30, the level-2 RRs must be configured as clients of level-1 RRs.


B.

It is recommended that RRs of the same level be configured with the same cluster ID.


C.

RRs of the same level must be configured as clients of each other.


D.

RTA and RTB can establish IBGP peer relationships with two level-1 RRs. RTA and RTB do not need to establish an IBGP peer relationship.


Expert Solution
Questions # 2:

In SRv6 BE scenarios, the original IPv6 packet encapsulation structure remains unchanged. SRv6 packets continue to be IPv6 packets and can be recognized by common IPv6 devices.

Options:

A.

TRUE


B.

FALSE


Expert Solution
Questions # 3:

Which of the following statements is not correct regarding the traditional metro network architecture?

Options:

A.

VPN services are carried on the SR. The OLT is connected to the SR directly or through a switch.


B.

A 4G wireless network and metro network can be converged.


C.

The MSE and SR are directly connected to the municipal CR, and the three devices belong to the same AS.


D.

The OLT is connected to the MSE directly or through a switch. The MSE carries HSI, VoIP, ITMS, and iTV services.


Expert Solution
Questions # 4:

Which of the following key factors must be considered when designing an IGW for an IP core network?

Select all that apply.

Options:

A.

Routing policy scale


B.

Hardware capacity of devices


C.

Route transport capability


D.

Security


Expert Solution
Questions # 5:

Which of these statements are correct regarding IS-IS reliability parameters on a 5G transport network?

Select all that apply.

Options:

A.

It is recommended that you set the maximum delay, initial delay, and each incremental delay to 1s, 50 ms, and 50 ms respectively for the SPF calculation timer.


B.

It is recommended that you enable TI-LFA and deploy microloop avoidance.


C.

It is recommended that GR be enabled so that the neighbor status and database remain unchanged after the neighbor relationship is disconnected.


D.

It is recommended that you set the maximum delay, initial delay, and each incremental delay to 1s, 50 ms, and 50 ms respectively for the LSP generation timer.


Expert Solution
Questions # 6:

Which of the following statements regarding EVPN on a 5G transport network is incorrect?

Options:

A.

EVPN L3VPN routes appear only in the EVPN routing table, not in the display bgp vpnv4 all routing-table command output.


B.

In the IP VPN instance of each device, the RT needs to be changed to be advertised in the EVPN address family.


C.

If EVPN is used to carry L3VPN services, you must run the advertise l2vpn evpn command in the BGP-VPN instance IPv4 address family view. Otherwise, routes are advertised through VPNv4 by default.


D.

When SR tunnels are used to carry EVPN traffic, the evpn mpls routing enable command must be run in the VPN instance view.


Expert Solution
Questions # 7:

With sub-interface-based HQoS, only one flow queue profile may be applied to a channelized sub-interface.

Options:

A.

TRUE


B.

FALSE


Expert Solution
Questions # 8:

Which of the following statements regarding the telco cloud network are correct?

Select all that apply.

Options:

A.

If two DC GWs are single-homed to PEs, you are advised to adjust route preference in a way that traffic from the two DC GWs uses different PEs as next hops. Otherwise, one PE may become overloaded.


B.

If the management & storage network and service network are deployed independently, they are physically isolated. If one network is attacked, the other network continues to run as usual, ensuring overall security.


C.

The service network uses the flattened spine-leaf architecture to provide high bandwidth, elastic scalability, and flexible access.


D.

As the telco cloud network expands, some sites that use box-shaped devices as DC GWs may fail to meet the bandwidth requirements of north-south service traffic, yet carriers may not want to replace existing DC GWs with high-capacity ones. In this case, the egress bandwidth of the telco cloud network can be increased by adding more DC GWs.


Expert Solution
Questions # 9:

Assume Flex-Algo is configured on a device and a tunnel policy is set for the device to preferentially select a Flex-Algo-based SR-MPLS BE tunnel. Under which of the following conditions would a VPN route recurse to the Flex-Algo-based SR-MPLS BE tunnel?

Select all that apply.

Options:

A.

Affinity


B.

Color attribute


C.

Next-hop address of the route


D.

Algorithm ID


Expert Solution
Questions # 10:

When synchronizing LSDBs over a P2P network, IS-IS does not need to send CSNPs.

Options:

A.

TRUE


B.

FALSE


Expert Solution
Viewing page 1 out of 2 pages
Viewing questions 1-10 out of questions