Pass the Huawei Transmission H31-311_V2.5 Questions and answers with CertsForce

Viewing page 4 out of 8 pages
Viewing questions 31-40 out of questions
Questions # 31:

The interval between two adjacent pointer alignment events is at least () frames.

Options:

A.

5


B.

4


C.

3


D.

2


Expert Solution
Questions # 32:

The OTN signal has a fixed pad period, the same frame period as the SDH signal.

Options:

A.

True


B.

False


Expert Solution
Questions # 33:

Which of the following is not a condition that triggers multiplexed segment protection (MSP)?

Options:

A.

MS-AIS signal was detected.


B.

Au-AIS detected.


C.

R-LOS detected.


D.

Check to R-LOF.


Expert Solution
Questions # 34:

Which of the following is the multiplexing method of SDH?

Options:

A.

flexible mapping


B.

Asynchronous multiplexing


C.

flexible mapping and asynchronous multiplexing


D.

Flexible mapping and synchronization multiplexing


Expert Solution
Questions # 35:

Subnetwork connection protection (SNCP) requires the APS protocol.

Options:

A.

TRUE


B.

FALSE


Expert Solution
Questions # 36:

After a user adjusts service bandwidth, the NCE Controller delivers the new bandwidth to devices and adjusts the CIR and PIR of the service PW. During the adjustment, services are not interrupted.

Options:

A.

FALSE


B.

TRUE


Expert Solution
Questions # 37:

Forced switching, fiber switching, manual switching and motion switching are decreased in order of priority.

Options:

A.

True


B.

False


Expert Solution
Questions # 38:

If a network port that supports autonegotiation is connected to a network port that does not support autonegotiation, you can interconnect in both half-duplex and full-duplex modes.

Options:

A.

True


B.

False


Expert Solution
Questions # 39:

Which of the following is the main networking type of a transmission network?

Options:

A.

Chain network


B.

P2P network


C.

Mesh network


D.

Ring network


Expert Solution
Questions # 40:

The backplane has two 48V power cords, and each board gets two -48V power supplies from the backplane. After combining the power supply via diodes, the various voltages required for each component are obtained by means of a DC/DC power module and a linear mane swap.

Options:

A.

True


B.

False


Expert Solution
Viewing page 4 out of 8 pages
Viewing questions 31-40 out of questions