1. Home
  2. HP
  3. Aruba Certified Switching Associate (ACSA) V1
  4. HPE6-A72
  5. Aruba Certified Switching Associate Exam Questions and Answers

Pass the HP Aruba Certified Switching Associate (ACSA) V1 HPE6-A72 Questions and answers with CertsForce

 HP Exams      Go to Exam Detail      Get Premium Access
Viewing page 1 out of 4 pages
Viewing questions 1-10 out of questions
Questions # 1:

Refer to the exhibit.

Question # 1

What does the command page result in?

Options:
A.

Starts an automatic page scrolling effect that pauses for a few seconds every 30 rows.

B.

Enables a terminal notification when a new debug event occurs for L2MAC events.

C.

Shows a new terminal window opening to allow typing while debugging occurs.

D.

Results in a page break to disable the default continuous scrolling In the console.

Questions # 2:

Match each network protocol to the correct default listening port and transport protocol. Not all answers will be used.

Question # 2

Questions # 3:

Interface 1/1/1 is up

Admin state is up

Link transitions: 1

Description: TO_PC-1

Hardware: Ethernet, MAC Address: 00:11:22:33:44:55

MTU 1500

Type 1GbT

Full-duplex

qos trust none

Speed 1000 Mb/s

Auto-negotiation is on

Flow-control: off

Error-control: off

MDI mode: MDIX

VLAN Mode: access

Access VLAN: 1111

Which command will produce the above output?

Options:
A.

show interface vlan 1111

B.

show interface 1/1/1

C.

show interface gigabit 1/1/1

D.

show vlan 1111

Questions # 4:

Refer to the exhibit.

Question # 4

Question # 4

What command will display the debug l2mac events?

Options:
A.

show module L2MAC

B.

show debug terminal

C.

show debug buffer module L2MAC

D.

show debug all

Questions # 5:

Match the term to the correct description.

Question # 5

Questions # 6:

What is Deep Packet Inspection?

Options:
A.

a machine learning method of packet inspection for the purpose of choosing which dynamic routing protocol to automatically assign

B.

a concept that applies to firewalls, when examining packets only up through Layer 4

C.

a function of Policy Based Routing that examines the entire IPv4 header to forward traffic based on factors other than destination address

D.

a firewall process of examining the packet header all the way to Layer 7 in order to determine if the packet should be permitted or denied

Questions # 7:

Refer to the exhibit

Question # 7

Which command on Access-2 port 1/1/4 will enable connectivity between PC-1 and Server-1 without any routing enabled in the network?

Options:
A.

Access-2 (config-if-1/1/4)# vlan access 1, 10, 20, 255

B.

Access-2 (config-if-1/1/4)# vlan access 20

C.

Access-2 (config-if-1/1/4)# vlan 20 untag 1/1/4

D.

Access-2 (config-if-1/1/4)# vlan trunk allow 1, 10, 255

Questions # 8:

What are the benefits of a 3-Tier design over a 2-Tier? (Choose two.)

Options:
A.

Offloading processing from the Core without routing at the Access layer.

B.

Can use lower speed links between Core to Aggregation and Aggregation to Access given the use of an Aggregation layer.

C.

Lowering the cost of a deployment due to needing less switches overall.

D.

Better scalability in a campus with a large number of buildings.

E.

Gaining the flexibility to connect the Data-Center to any Access layer switch.

Questions # 9:

Refer to the exhibit.

Question # 9

What commands will successfully enable the SVI for vlan 100 on interface 1/1/1 to produce the results displayed in the commandshow ip interface briefin the exhibit below?

Question # 9

Options:
A.

Access-1(config)# interface 1/1/1

Access-1(config-if)# routing

Access-1(config-if)# interface vlan 100

Access-1(config-if-vlan)# ip address 10.1.1.1/24

B.

Access-1(config)# interface 1/1/1

Access-1(config-if)# vlan trunk permit vlan 100

Access-1(config-if)# interface vlan 100

Access-1(config-if-vlan)# ip address static 10.1.1.1/24

C.

Access-1(config)# interface vlan 100

Access-1(config-if-vlan)# ip address 10.1.1.1/24

D.

Access-1(config-if)# vlan 100

Access-1(config-vlan)# ip address 10.1.1.1/24

Questions # 10:

Match the available stacking feature to the correct AOS-CX switch model. Stacking features may be used more than once.

Question # 10

Viewing page 1 out of 4 pages
Viewing questions 1-10 out of questions