-- Exhibit –
-- Exhibit --
Refer to the exhibit.
An LTM Specialist sets up AVR alerts and notifications for a specific virtual server if the server latency exceeds 50ms. The LTM Specialist simulates a fault so that the server latency is consistently exceeding the 50ms threshold; however, no alerts are being received.
Which configuration should the LTM Specialist modify to achieve the expected results?
An application is being load balanced through the LTM device using the configuration displayed below.
The network has been re-engineered to NAT all client connection. As a result, allclient connections are hitting the same pool member.
Which changes should the LTM Specialist make in order to restore load balancing functionality wile maintaining session persistence?
An ITM Specialist has the configuration shown:
The LTM Specialist needs to create a new virtual server in part B.
Which virtual address(es) should be used for the new virtual server?
The end users of a web application need to verify that their browsers received the complete message-body from the web server.
Which HTTP header will accomplish this?
An LTM device is monitoring pool members on port 80. The LTM device is using an HTTP monitor with a send string of GET / and a blank receive string.
What would cause the pool members to be marked down?
Which file should the BIG-IP Administrator check to determine when a Virtual Server changed its status
A new iRule needs to be tested. The LTM Specialist needs to measure page load times and monitor potential changes in memory usage A load test is scheduled.
Which two featuresshould the LTM Specialist use to monitor these requirements? (Choose two.)
-- Exhibit –
-- Exhibit --
Refer to the exhibit.
A failover has just occured on BIG-IP1. BIG-IP2 is now active and manages traffic as expected. Both Bigip's are set with a gateway failsafe to check the reachability of the main border router. Switches have performed as expected.
Where should the LTM Specialist check for potential issues?
An LTM Specialist needs to use the tmsh command to create a pool named http_pool with member
10.10.101:80 on an LTM device.
Which expression should the LTM Specialist use?
Which Virtual Server type prevents the use of a default pool?
An application owner claims an LTM device is delaying delivery of an HTTP application. The LTM device has two VLANs, an internal and an external. The application servers reside on the internal VLAN. The virtual server and clients reside on the external VLAN.
With appropriate filters applied, which solution is most efficient for obtaining packet captures in order to investigate the claim of delayed delivery?
What should the 816-IP Administrator provide when opening a new ticket with F5 Support?
An LTM device load balances a pool of routers. The LTM device needs to verify pathavailability to an HTTP server with the IP address 192 168.10 10. located beyond the routers.
Which monitor type and parameters arc required?
During a high-demand traffic event, the BIG-IP Administrator needs to limit the number of new
connections per second allowed to a Virtual Server.
What should the administrator apply to accomplish this task?
-- Exhibit –
-- Exhibit --
Refer to the exhibit.
A virtual server is set up on an LTM device as follows:
Virtual server address 78.24.213.79
Default Persistence ProfilE. source_addr, 600s.
Pool NamE. Pool1
Pool Members: 10.72.250.52:80 and 10.72.250.60:80 (both on Internal Vlan)
There are several current connections to the virtual server, and pool member 10.72.250.52:80 has been set to a "Disabled" state.
A tcpdump on the Internal Vlan shows traffic going to 10.72.250.52:80.
How soon after the persistence table query was run can existing connections be refreshed/renewed to ensure that no requests are sent to 10.72.250.52?
