Comprehensive and Detailed Explanation
NetApp ONTAP AutoSupport continuously monitors system health and transmits diagnostic information to NetApp technical support. Depending on the event, AutoSupport notifications can initiate automatic support case creation.
During planned maintenance operations, such as cluster switch firmware upgrades, temporary network interruptions may generate health alerts and AutoSupport events.
To prevent these expected interruptions from generating unnecessary support cases, administrators should establish an AutoSupport maintenance window before beginning the upgrade.
The correct command is:
system node autosupport invoke -node * -type all -message MAINT=5h
The parameters operate as follows:
-node * applies the command to all cluster nodes.
-type all sends the AutoSupport notification to all configured destinations.
-message MAINT=5h establishes a five-hour maintenance window during which automatic support case creation is suppressed.
NetApp explicitly documents this command format in its cluster switch firmware and RCF upgrade procedures.
After completing the firmware upgrade, administrators can terminate the maintenance window early using:
system node autosupport invoke -node * -type all -message MAINT=END
Option A: STOP=5h is not the supported maintenance-window directive.
Option B: IGNORE=5h is not a valid AutoSupport case-suppression directive.
Option D: SUPPRESS=5h is not the supported syntax.
Therefore, C is correct. Importantly, maintenance mode suppresses automatic case creation rather than disabling AutoSupport monitoring and diagnostics.
Official NetApp References / Study Guide Topics:
NetApp Support Engineer ONTAP — Active IQ: AutoSupport integration, proactive monitoring, maintenance notifications, and automated support case management.
NetApp — AutoSupport Maintenance During Switch Upgrades
NetApp — Suppress Automatic Case Creation for Maintenance
=========================
Submit