Setting "forwarding=no" on a wireless interface prevents communication between connected clients on that interface and between that interface and other interfaces in the same bridge. This means:

Stations connected to wlan1 cannot talk to each other

Stations on wlan1 cannot talk to stations on wlan2 (even if bridged)

Stations on wlan2 can talk to each other normally

Evaluation:

A.✅Correct – forwarding=no does not affect wlan2

B.❌Incorrect – forwarding=no blocks this

C.✅Correct – clients on wlan1 cannot talk to each other either

D.❌Bridge filters can be used but this scenario is about forwarding settings

E.❌Blocked by forwarding=no

MTCNA Wireless Module – Wireless Forwarding Behavior:

“Forwarding=no disables client-to-client communication on the interface and across bridges.”

René Meneses Study Guide – Wireless Access Config:

“Use forwarding=no to isolate clients on the same AP. Affects bridging too.”

Terry Combs Notes – Wireless Isolation:

“Setting forwarding=no isolates all clients on that wireless card.”

Answer: A, CQUESTION NO: 81 [Wireless]

Consider a wireless access point with mode=ap-bridge. What is the maximum number of concurrent clients that can connect to it?

A. 2007

B. 2012

C. 2048

D. 1024

Answer: C

In MikroTik RouterOS, the theoretical maximum number of clients that can associate with an AP in ap-bridge mode is 2048. However, practical limits depend on hardware performance and network stability, and most real-world setups use far fewer clients.

Let’s review:

A. 2007 →❌Close, but not the actual hard limit

B. 2012 →❌Incorrect

C.✅2048 → Correct per MikroTik’s AP mode specification

D. 1024 →❌Lower than the actual maximum

MTCNA Wireless Module – AP Behavior:

“In ap-bridge mode, the maximum theoretical client limit is 2048. Actual stable operation may be lower.”

René Meneses Guide – Wireless Scaling:

“2048 is the upper limit for client associations on a MikroTik AP in bridge mode.”

Terry Combs Notes – Client Capacity:

“2048 clients = maximum. Performance may degrade before that in high-traffic environments.”