Huawei's separated subscriber-control and user-plane architecture allows several active UPs to share standby protection resources. A carrier deployment model describes N+1 warm protection, and independent Huawei vBNG interoperability testing establishes N:1 warm backup with one standby UP protecting multiple active nodes. When an active forwarding node fails, the control plane coordinates recovery and installs the subscriber/session and routing information required by the standby. Warm backup differs from 1:1 hot standby, in which much of the active forwarding state may be continuously replicated. The answer therefore selects the two warm-backup configurations.
Technical Deep Dive:
A and D are the intended answers. In N+1 protection, backup capacity exists in addition to the group of active resources. In N:1 warm backup a single standby protects N active user planes. The centralized vBRAS-CP monitors UP resources, coordinates selection of the recovery node and redeploys the affected subscriber information after a failure. This model optimizes spare hardware compared with dedicating a synchronized standby UP to each active UP. It may produce longer restoration times than 1:1 hot standby because forwarding entries are restored or reinstalled during failover rather than continuously synchronized. Restoration depends on subscriber population, policy/session complexity, UP processing speed, and forwarding-table installation rate. N+1 hot and N:1 cold backup do not match the intended vBRAS-UP protection models. Support for the exact N+1 nomenclature and deployment limits must be checked against the relevant Huawei product release.
Chosen Answer:
This is a voting comment (?). You can switch to a simple comment. It is better to Upvote an existing comment if you don't have anything to add.
Submit