Option A is incorrect under the standardized burst-based throughput measurement methodology because including the final small transmission interval can distort the measured throughput.
In NR performance management, throughput measurements are intended to represent radio transmission performance rather than the average application traffic rate across periods containing idle time.
The relevant measurement procedure distinguishes intervals during which the transmission buffer contains data from intervals when the buffer becomes empty.
The final transmission interval of a data burst may carry only a small residual packet. Including its duration and data volume can introduce a packet-size-dependent effect into the calculated throughput.
3GPP TS 28.554 therefore defines an extended throughput measurement method that excludes the final slot of the burst from the applicable calculation.
Option B is correct because average uplink and downlink UE throughput are used to assess radio-network performance as experienced by users.
Option C describes the general relationship between transmitted data volume and applicable active transmission time, subject to the precise measurement definitions.
Option D expresses a comparable throughput relationship at cell level, although its wording is less precise than the standardized KPI definitions.
Therefore, option A contradicts the specified throughput methodology.
Official Reference: 3GPP TS 28.554, Section 6.3.6.2, Extended Definition of Throughput , Figure 1; TS 28.552, 5G Performance Measurements .
Submit