To configure an AFTD device on "StorageNodeA" with the name "OracleBackup" using the folder "D:\AFTD" to the pool "Default", the administrator can use the Data Domain CLI (Command Line Interface) to access the Data Domain system and create the AFTD device. Here are the steps:

Log in to the Data Domain CLI by entering the following command:

ssh admin@StorageNodeA

Once logged in, create a new AFTD device named "OracleBackup" by entering the following command:

ddboost afd create --name OracleBackup --pool Default --folder D:\AFTD

Verify that the new AFTD device has been created by running the following command:

ddboost afd show --name OracleBackup

To make sure that the Oracle backups only use the specific storage node, you can assign the AFTD device to the Oracle backup host by running the following command:

ddboost afd set --name OracleBackup --host OracleBackupHost

Verify the configuration by running the following command:

ddboost afd show --name OracleBackup

To make sure that the StorageNodeA is a dedicated storage node, you can configure the storage node to only allow the OracleBackup host to use the AFTD device by running the following command:

ddboost host access add --host OracleBackupHost --afd OracleBackup

Finally, the administrator should select the “Apply” button to save the configuration.

References: [1] https://www.delltechnologies.com/en-us/storage/powerprotect-dd/documentation.htm#Configuration_Guide