The RF energy that exists in the environment from intentional and unintentional RF radiators that forms the baseline above which the intentional signal of your WLAN must exist is the best explanation of the noise floor noted in the report. The noise floor is a term that describes the level of background noise or interference in a wireless channel or band. The noise floor is measured in dBm (decibel-milliwatts) and it represents the minimum signal strength that can be detected or received by a wireless device. The noise floor is influenced by various factors, such as the sensitivity of the receiver, the antenna gain, the cable loss, and the ambient RF environment. The ambient RF environment consists of intentional and unintentional RF radiators that emit RF energy in the wireless spectrum. Intentional RF radiators are devices that are designed to transmit RF signals for communication purposes, such as Wi-Fi access points, Bluetooth devices, microwave ovens, or cordless phones. Unintentional RF radiators are devices that are not designed to transmit RF signals but generate electromagnetic radiation as a by-product of their operation, such as USB 3 devices, PC power supplies, or fluorescent lights. The noise floor affects WLAN performance and quality because it determines the minimum signal-to-noise ratio (SNR) that is required for a successful wireless transmission. SNR is the difference between the signal strength of the desired signal and the noise floor of the channel. SNR is also measured in dB and it indicates how much the signal stands out from the noise. A higher SNR means a better signal quality and a lower bit error rate. A lower SNR means a worse signal quality and a higher bit error rate. Therefore, to achieve a reliable WLAN connection, the intentional signal of your WLAN must exist above the noise floor by a certain margin that depends on the data rate and modulation scheme used. The other options are not accurate or complete explanations of the noise floor noted in the report. The noise caused by elevators, microwave ovens, and video transmitters is not the noise floor but rather examples of interference sources that contribute to the noise floor. The extra energy radiated by access points and client devices beyond that intended for the signal is not the noise floor but rather an example of spurious emissions that cause interference to other devices or channels. The energy radiated by flooring materials that causes interference in the 2.4 GHz and 5 GHz bands is not the noise floor but rather an example of attenuation or reflection that reduces or changes the direction of the signal. References: CWNA-109 Study Guide, Chapter 5: Radio Frequency Signal and Antenna Concepts, page 139