A VoIP phone, using WMM Power Save, requests data frames buffered at the AP by transmitting a trigger frame, which is a QoS Null frame or a QoS Data frame. WMM Power Save is a power saving mode that allows a STA (station) to conserve battery power by periodically sleeping and waking up. WMM Power Save is based on WMM (Wi-Fi Multimedia), which is a QoS (Quality of Service) enhancement that provides prioritized and differentiated access to the medium fordifferent types of traffic. When a STA sleeps, it cannot receive any data frames from the AP, so it informs the AP of its power save status by setting a bit in its MAC header. The AP then buffers any data frames destined for the sleeping STA until it wakes up. When a STA wakes up, it sends a trigger frame to the AP, indicating its AC (Access Category), which is a logical queue that corresponds to its QoS level. A trigger frame can be either a QoS Null frame or a QoS Data frame, depending on whether it has any payload or not. The AP then responds with one or more data frames from the same AC as the trigger frame, followed by an ACK or BA (Block Acknowledgement) frame from the STA. The other options are not correct, as they are not used by a VoIP phone using WMM Power Save to request data frames buffered at the AP. A PS-Poll (Power Save Poll) frame is used by a STA using legacy power save mode, not WMM Power Save mode, to request data frames buffered at the AP. A PS-Poll frame does not indicate any AC or QoS information. Setting the More Data bit in the MAC header to 1 does not request any data frames from the AP, but indicates that there are more data frames to be sent by the STA or received by the STA. Transmitting a WMM Action frame does not request any data frames from the AP, but performs various management actions related to WMM features, such as admission control, parameter update, etc. References: [Wireless Analysis Professional Study Guide CWAP-404], Chapter 7: QoS Analysis, page 198-199