Refer to the exhibit. An engineer applied filter on R1 The interface flapped between R1 and R2 and cleaning the BGP session did not restore the BGP session and failed Which action must the engineer take to restore the BGP session from R2 to R1?
A.
Apply the IPv6 traffic filter in the outbound direction on the interface
B.
ICMPv6 must be permitted by the IPv6 traffic filter
C.
Enable the BGP session, which went down when the session was cleared.
D.
Swap the source and destination IP addresses in the IPv6 traffic filter
Chosen Answer:
This is a voting comment (?). You can switch to a simple comment. It is better to Upvote an existing comment if you don't have anything to add.
Submit