An AVC rule associates an application with an action. The available actions are mark, drop and rate-limit. To prioritise the traffic of IP cameras, the engineer must assign the traffic a higher QoS value than it would normally receive, and the mark action does exactly that by setting the DSCP value that the network will then treat with the required priority. Dropping would block the cameras, and rate-limiting restricts the bandwidth that they may use, which is the opposite of prioritisation. A permit ACL and WMM required are not elements of an AVC rule. WMM is a WLAN-level setting, and an ACL is a separate construct that does not belong in the rule definition. After the profile is created with the mark rule for the camera application, it is applied to the WLAN or policy profile, and the controller then remarks matching flows accordingly. Remember that the other available actions are drop and rate-limit, and that a rule is always tied to a specific application recognised by NBAR2 deep packet inspection.
Chosen Answer:
This is a voting comment (?). You can switch to a simple comment. It is better to Upvote an existing comment if you don't have anything to add.
Submit