An organization is concerned about site-specific 802.1X authentication in the event of a WAN outage in their Cisco FlexConnect deployment. Which data is needed to accomplish this authentication?
For 802.1X to keep working at a branch during a WAN outage, the APs must be able to reach a RADIUS server that is located at the site. In a FlexConnect group the administrator defines the local, primary and optionally secondary, RADIUS server together with the shared secret that the APs use to communicate with it, and enables local authentication for the WLAN. When the CAPWAP tunnel is lost, the APs authenticate clients directly against that server. The information needed is therefore the shared secret of the local RADIUS server, together with its address. The central RADIUS secret is used by the controller and would be of no use if the WAN is down and the central server is unreachable. TACACS+ is a device administration protocol and plays no role in client 802.1X authentication. The local RADIUS shared secret is the required data. The FlexConnect group configuration therefore needs the RADIUS server address and its shared secret, entered for the local authentication server, before the WAN failure takes place.
[Reference:Blueprint 1.2.a (FlexConnect groups) and 1.1 (operating modes); Cisco Catalyst 9800 FlexConnect Branch Deployment Guide, backup RADIUS and local authentication., ]
Contribute your Thoughts:
Chosen Answer:
This is a voting comment (?). You can switch to a simple comment. It is better to Upvote an existing comment if you don't have anything to add.
Submit