On the Catalyst 9800 the Hyperlocation function is configured in the AP join profile. The Cisco configuration guide describes the GUI path as Configuration > Tags & Profiles > AP Join, then, in the AP join profile under the AP tab, the Hyperlocation tab with the Enable Hyperlocation check box. The same tab holds the detection threshold, in a range from -100 dBm to -50 dBm, and the NTP server that the APs use for time synchronisation. In the CLI the equivalent is the hyperlocation command inside the ap profile context. Hyperlocation is therefore an AP-level feature that is applied through the AP join profile. A policy profile controls client behaviour such as VLAN, QoS and AAA. The Flex profile holds branch parameters, and the RF profile defines radio settings, so none of these three is the location where the feature is switched on. Remember that in the same AP join profile the NTP server for the APs is also entered, because Hyperlocation depends on accurate time synchronisation.
[Reference:Blueprint 4.2 (Implement location services); Cisco Catalyst 9800 Series Software Configuration Guide, Cisco Hyperlocation (AP join profile). Source key listed D; corrected to B (see appendix)., ]
Contribute your Thoughts:
Chosen Answer:
This is a voting comment (?). You can switch to a simple comment. It is better to Upvote an existing comment if you don't have anything to add.
Submit